81.040.01 玻璃综合 标准查询与下载

KS L 2108-2021 玻璃基板上薄膜附着力的测试方法

Testing methods for adhesion of thin films on glass substrate

KS L 2105-2021 激光干涉法测量低膨胀玻璃线性热膨胀系数的方法

Measuring method of the linear thermal expansioncoefficient for low expansion glass by laser interferometry

KS L 2526-2021 氟化物玻璃化学耐久性测试方法

Testing method for chemical durabilities of fluoride glasses

DIN ISO 720:2021 玻璃 玻璃颗粒在 121°C 下的耐水解性 测试方法和分类（ISO 720:2020）

This document specifies a method for determining the hydrolytic resistance of glass grains at 121 °C. The resistance is measured and expressed by the volume of acid required for titration of the alkali extracted from the unit mass of glass, and can also be expressed by the amount

Glass - Hydrolytic resistance of glass grains at 121 °C - Method of test and classification (ISO 720:2020)

DIN ISO 719:2021 玻璃 玻璃颗粒在 98°C 下的耐水解性 测试方法和分类（ISO 719:2020）

This document specifies a method for determining the hydrolytic resistance of glass grains at 98 °C. The resistance is measured and expressed by the volume of acid required for titration of the alkali extracted from the unit mass of glass, and can also be expressed by the amount

Glass - Hydrolytic resistance of glass grains at 98 °C - Method of test and classification (ISO 719:2020)

T/ZBH 019-2021 玻璃应力测量方法——激光偏振散射法

本文件规定了测量玻璃应力的激光偏振散射法的术语和定义、基本原理、测量仪器、测量、测量结果、测量报告。 本文件的方法适用于以钠钙硅平板玻璃及压花玻璃、硼硅酸盐平板玻璃作为原片制成的钢化、半钢化玻璃的表面应力和板厚方向应力分布，以及外力引起的玻璃应力的实验室及现场测量。其他种类的钢化玻璃可参照本文件。

Test method for stress of glass—Laser polarization scattered-light method

T/SDG 003-2021 建筑幕墙用中空玻璃

本文件规定了建筑幕墙用中空玻璃的术语和定义、分类、要求、试验方法、检验规则、包装、标志、运输和贮存 对“建筑幕墙用中空玻璃”从质量、形状、中空腔数量、腔内气体方面进行了细化分类； 提高了“尺寸偏差、露点”等重要技术指标值‘ 增加了钢化玻璃自爆、自爆率的定性描述及减少钢化玻璃自爆的主要方法； 增加了对弯曲度、光学变形、影像变形，及相对应检验方法的规范和规定； 增加了不同气候区域条件下玻璃配置推荐；

Insulating glass unit for building curtain wall

GSO ISO 9385:2021 玻璃和微晶玻璃 努氏硬度测试

-

Glass and glass-ceramics — Knoop hardness test

GSO ASTM E2188:2021 中空玻璃单元性能的标准测试方法

1.1 This test method covers procedures for testing the performance of preassembled permanently sealed insulating glass units or insulating glass units with capillary tubes intentionally left open. 1.2 This test method is applicable only to insulating glass units that are constructed with glass. 1.3 This test method is applicable to both double-glazed and triple-glazed insulating glass units. For triple-glazed insulating glass units where both of the outer lites are glass and the inner lite is either glass or a suspended film. 1.4 The unit construction used in this test method contains dimensions that are an essential component of the test. Different types of glass, different glass thicknesses, and different cavity sizes may affect the test results. 1.5 This test method is not applicable to insulating glass units containing a spandrel glass coating due to testing limitations. 1.6 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Insulating Glass Unit Performance

T/CBMF 99-2021 玻璃、釉料及其原料的化学分析方法 电感耦合等离子体原子发射光谱法

本文件规定了用电感耦合等离子体原子发射光谱法（ICP-AES）测定玻璃、釉料及其原料中多种元素含量的方法。 本文件适用于玻璃、釉料及其原料中多元素含量的测定，具体元素及测定范围见表1。

Determination of glass, glazes and their raw materials—Inductively coupled plasma atomic emission spectrometry method

GOST 26302-2021 建筑玻璃 直射透光系数测定法

Glass. Light regular transmittance and light regular reflectance determination methods

GOST 22290-2021 石英玻璃 结晶稳定性试验法

Vitreous silica transparent glass. Crystallization stability test method

GOST 22292-2021 透明石英玻璃 在热加工后变暗稳定性测定法

Silica transparent glass. Method for determination of stability to darkening after thermal treatment

GOST 22291-2021 石英玻璃 化学稳定性测定法

Silica glass. Method for determination of chemical stability

KS L 2404-2020 水晶玻璃化学分析方法

Method for chemical analysis of crystal glass

NF S90-072:2020 玻璃. 玻璃晶粒在121℃时的耐水解性. 试验方法和分类

Domaine d'applicationLe présent document spécifie:a) une méthode de détermination de la résistance hydrolytique du verre en grains à 121 oC. La résistance est mesurée et exprimée par le volume d'acide nécessaire au titrage de l'alcali extrait par unité de masse de verre, et peut

Glass - Hydrolytic resistance of glass grains at 121 oC - Method of test and classification

NF S90-071:2020 玻璃. 玻璃晶粒在98℃时的耐水解性. 试验方法和分类

Le présent document spécifie:a) une méthode de détermination de la résistance hydrolytique du verre en grains à 98 oC. La résistance est mesurée et exprimée par le volume d'acide nécessaire au titrage de l'alcali extrait par unité de masse de verre, et peut également être exprimé

Glass - Hydrolytic resistance of glass grains at 98 oC - Method of test and classification

BS ISO 719:2020 玻璃 玻璃颗粒在 98 °C 下的耐水解性 测试方法和分类

What is ISO 719 about?    ISO 719 is intended for use on the less resistant types of glass, such as soda-lime glass. Soda lime glass has several properties that make it useful as a glass for general and more specific applications.   ISO 719 specifies the method for determining the hydrolytic resistance of glass grains at 98 °C. The resistance is measured and expressed by the volume of acid required for titration of the alkali extracted from the unit mass of glass and can also be expressed by the amount of sodium oxide equivalent to this volume of acid.   ISO 719 also describes the classification of glass according to the hydrolytic resistance determined by the method of this document. For five classes of grain the limit values in the test are listed. The principle, reagents, apparatu...

Glass. Hydrolytic resistance of glass grains at 98 °C. Method of test and classification

BS ISO 720:2020 玻璃 玻璃颗粒在 121 °C 下的耐水解性 测试方法和分类

What is ISO 720 about?    More resistance glass has become useful in a wide variety of industries and applications, because of its physical and chemical properties. ISO 720 is intended for use on the more resistant types of glass, e.g., borosilicate glass.   ISO 720 specifies the method for determining the hydrolytic resistance of glass grains at 121 °C. The resistance is measured and expressed by the volume of acid required for titration of the alkali extracted from the unit mass of glass and can also be expressed by the amount of sodium oxide equivalent to this volume of acid.   ISO 720 also describes the classification of glass according to the hydrolytic resistance determined by the method of this document.

Glass. Hydrolytic resistance of glass grains at 121 °C. Method of test and classification

ISO 720:2020 玻璃.玻璃颗粒在121℃下的耐水解性.试验和分类方法

This document specifies a) a method for determining the hydrolytic resistance of glass grains at 121 °C. The resistance is measured and expressed by the volume of acid required for titration of the alkali extracted from the unit mass of glass, and can also be expressed by the amount of sodium oxide equivalent to this volume of acid, and b) a classification of glass according to the hydrolytic resistance determined by the method of this document. This document is intended for use on the more resistant types of glass, e.g. borosilicate glass. NOTE 1 For the less resistant glasses, e.g. soda-lime, the method specified in ISO 719 is more suited. NOTE 2 It is emphasized that there is no exact correlation between the classification laid down in this document and that laid down in ISO 719, and it is, therefore, essential to identify which classification is being used.

Glass — Hydrolytic resistance of glass grains at 121 °C — Method of test and classification