87.060.30 溶剂 标准查询与下载

JIS K 5601-2-2:1999 涂料成份的试验方法.第2部分:溶剂溶解物质的成份分析.第21节:软化点(环和球法)

この規格は，環球式装置による樹脂(ロジンも含む。)及び類似品の軟化点測定方法について規定する。

Testing methods for paint components -- Part 2: Component analysis in solvent soluble matter -- Section 2: Softening point (Ring and ball method)

JIS K 5601-2-3:1999 涂料成份的试验方法.第2部分:溶剂溶解物质的成份分析.第3节:沸腾范围

1.1この規格は，常圧で30～300 ℃で沸騰し，化学的に安定であり，蒸留時に装置を腐食しない液体の沸点範囲を測定する方法を規定する。1.2この方法は，炭化水素，エステル，アルコール，ケトン，エーテル及びその類似品の有機液体に適用できる。

Testing methods for paint components -- Part 2: Component analysis in solvent soluble matter -- Section 3: Boiling range

JIS K 5601-3-1:1999 涂料成份的试验方法.第3部分:溶剂溶解物质的成份分析.第1节:总铅量(火焰原子吸收光谱法)

この規格は，塗料及び関運製品中の全鉛含有量を測定するための，フレーム原子吸光分析法について規定する。この方法は，約0.01-2 %(m/m)の範囲の全鉛含有量をもつ製品に適用できる。

Testing methods for paint components -- Part 3: Component analysis in solvent insoluble matter -- Section 1: Total leads (Flame atomic absorption spectrometric method)

ASTM D3620-98 冰醋酸标准规范

1.1 This specification covers glacial (99.8%) acetic acid for use in paint, varnish, lacquer, and related products. 1.2 For specific hazard information and guidance, see the supplier's Material Safety Data Sheet for materials listed in this specification.

Standard Specification for Glacial Acetic Acid

DIN 55998:1998 油漆和清漆用溶剂.丙二醇.供货规范,进一步要求和试验方法

The document describes supply specification, further requirements and test methods for propylene glycol ethers as solvent for paints and varnishes.#,,#

Solvents for paints and varnishes - Propylene glycol ethers - Supply specification, further requirements and methods of test

ASTM D2693-93(1997) 乙二醇标准规格

Standard Specification for Ethylene Glycol

DIN 53246:1997 漆和涂料溶剂.醋酸脂.交货技术条件、其它性能和检验

Solvents for paints and varnishes - Acetic esters - Delivery specification, further requirements and methods of test

DIN 53247:1997 油漆和类似涂料的溶剂.酮.供货规范、其他要求和试验

The document specifies the supply specification for ketones intended as solvents for paints and varnishes.

Solvents for paints and varnishes - Ketones - Supply specifications, further requirements and methods of test

JIS K 3151:1996 为确保涂料、清漆和相关涂层良好的粘着性采用磷酸盐转化涂层的推荐标准

この規格は，鉄鋼表面の塗装下地用りん酸塩化成処理剤について規定する。

Recommendations for phosphate conversion coatings to ensure good adhesion of paints, varnishes and related coatings

ASTM D4734-96a 精制苯-545的标准规范

Standard Specification for Refined Benzne-545

ASTM D4734-96 精制苯-545的标准规范

Standard Specification for Refined Benzne-545

SNI 13-4112-1996 涂料. 高岭土技术规范与测试方法

Specification and test method of kaolin for paint

ASTM D2403-96(2003)e1 精制邻苯二(甲)酸酐-1308的标准规范

1.1 This specification covers refined phthalic anhydride-1308.1.2 The following applies to all specified limits in this specification: for purposes of determining conformance with this specification, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.1.3 Consult current OSHA regulations, supplier''s Material Safety Data Sheets, and local regulations regarding all material used in this specification.

Standard Specification for Refined Phthalic Anhydride-1308

ANSI/ASTM D3698:1996 溶剂蒸气脱脂操作惯例

This practice recommends work practices for conventional vapor degreasing operations utilizing any solvent or solvent blend that has been categorized as nonflammable. This practice is not intended for use in vapor degreasing operations utilizing flammable (low flash point) solvents or in vapor degreasing operations utilizing enclosed (sealed, airtight) equipment. For these non-applicable operations, users should consult the solvent or equipment supplier for additional information. The values given in inch-pound units are to be regarded as the standard. The values stated in parentheses are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Practice for Solvent Vapor Degreasing Operations

ANSI/ASTM D2943:1996 1,1,1-三氯乙烷铝划痕试验方法

This is a screening test method to determine if sufficient inhibitors are present in 1, 1, 1-trichloroethane to provide at least minimal stability in the presence of aluminum. Solvent passing this test method may not be stable for all applications. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific hazard statement is given in Section 6.

Test Method for Aluminum Scratch of 1,1,1-Trichloroethane

ANSI/ASTM D2942:1996 卤化有机溶剂总酸容量测定方法

This test method covers the determination of the total acid acceptance including amine and neutral type (alpha epoxide) stabilizers in halogenated organic solvents. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 7.

Test Method for Total Acid Acceptance of Halogenated Organic Solvents (Nonreflux Methods)

ANSI/ASTM D2251:1996 卤化有机溶剂或其搀合物进行金属腐蚀试验方法

This test method covers the evaluation of the corrosiveness to metals by halogenated organic solvents and their admixtures for cold cleaning applications. Note 1The test method described herein is an adaptation of Test Method D 130. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Test Method for Metal Corrosion by Halogenated Organic Solvents and their Admixtures

BS 3761:1995 溶剂基涂料去除剂规范

This British Standard specifies requirements for solvent-based paint removers applied by brush. The paint removers are intended for general use on surfaces of painted, varnished or lacquered wood, plaster or metal. As supplied, paint removers conforming to this standard will be non-flammable and will not be suitable for some substrates (see foreword).

Specification for solvent-based paint remover

JIS K 5538:1995 天然漆稀释剂

Lacquer thinner

DIN 53249:1995 颜料、清漆和类似涂层材料用溶剂.二戊烯.要求和试验方法

The document describes requirements and test methods for dipentene as solvent for paints and varnishes.

Solvents for paints, varnishes and similar coating materials - Dipentene - Requirements and methods of test