G35 合成橡胶 标准查询与下载

GB/T 12824-2002 苯乙烯-丁二烯橡胶(SBR)1502

本标准规定了苯乙烯-丁二烯橡胶（SBR）1502（以下简称“SBR 1502”）的技术要求，试验方法，检验规则以及包装、标志、储存、运输等要求。 本标准适用于以丁二烯和苯乙烯为单位，以歧化松香酸钾皂和脂肪酸皂混合物为乳化剂，采用低温乳液聚合法，添加非污染型防老剂而制得的SBR 1502。

Rubber,styrene-butadiene (SBR) 1502

GB/T 8659-2001 丁二烯橡胶(BR)9000

本标准规定了丁二烯橡胶（BR）9000的技术要求、试验方法、检验规则及标志、包装、贮存、运输等要求。 本标准适用于1,3-丁二烯在镍催化体系下经溶液聚合制得的顺式-l,4聚丁二烯橡胶。

Rubber,butadiene (BR) 9000

GB/T 15257-1994 混合调节型氯丁橡胶 CR321、CR322

本标准规定了调节型氯丁橡胶CR3211、CR3212、CR3213（简称CR321）和混合调节非污染型氯丁橡胶CR3221、CR3222、CR3223（简称CR322）的牌号规定及划分、技术条件检验方法、验收规则及包装、标志、运输、贮存。 本标准适用于以氯丁二烯为单体，硫黄和调节剂丁为调节剂，经乳液聚合制得的氯丁橡胶CR321、CR322。

Mixed modulation chloroprene rubber CR321,CR322

GB/T 14647-1993 氯丁橡胶 CR121

本标准规定了氯丁橡胶CR121（简称CR121）牌号规定及划分，技术条件、检验方法、验收规则及包装、标志、运输、贮存。 本标准适用于以氯丁二烯为单体，硫磺为分子量调节剂，经乳液聚合而制得的CR121。

Chloroprene rubber CR121

GB 8655-1988 丁苯橡胶(SBR)1500

本标准规定了丁苯橡胶（SBR）1500的技术要求、试验方法、检验规则以及包装、标志、贮存、运输等要求。 本标准适用于以丁二烯和苯乙烯单体为主要原料，以松香酸钾皂或其混合皂为乳化剂，采用低温乳液聚合法而制得的SBR1500。

Rubber, styrene--butadiene (SBR) 1500

GB 7040-1986 旋转轴唇形密封圈用胶料

Rubber compounds for rotary shaft lip seals

GB 7039-1986 往复运动用密封圈胶料

Rubber compounds for sealing ring of reciprocating applications

SH/T 1833-2022 合成生橡胶色差的测定 色差仪法

Determination of color difference for raw synthetic rubber – Colorimeter method

HG/T 6011-2022 粉末苯乙烯-丁二烯橡胶

Powder styrene-butadiene rubber

ISO 4647:2021 硫化橡胶. 与纺织窜线静态粘合强度的测定. H-抽出试验

This document specifies a method for the determination of the static adhesion of textile cord to vulcanized rubber using the H-pull test. It is applicable to cords made from natural or man-made fibres. The property levels obtained with this method are affected considerably by the history of the cord and the rubber compound. The method yields data, however, on which a judgement as to the service quality of the material can be based. The method is primarily intended for use with tyre cord. However, it can be applied, if desired, to similar cords for use in other rubber products, but it is limited to cords of linear density not exceeding 800 mg/m (tex).

Rubber, vulcanized - Determination of static adhesion to textile cord - H-pull test

DIN ISO 48-9:2021 硫化橡胶或热塑性橡胶. 硬度的测定. 第9部分: 硬度测试仪的校准和验证(ISO 48-9-2018)

This document specifies procedures for the calibration and verification of durometers of types A, D, AO and AM (see ISO 48-4), IRHD pocket meters (see ISO 48-5), IRHD dead-load instruments (see ISO 48-2) and dead-load instruments using the very low rubber hardness scale (see ISO

Rubber, vulcanized or thermoplastic - Determination of hardness - Part 9: Calibration and verification of hardness testers (ISO 48-9:2018)

SH/T 1831-2020 丙烯腈-丁二烯橡胶中游离丙烯腈含量的测定 顶空气相色谱法

Determination of free acrylonitrile content in acrylonitrile-butadiene rubber by headspace gas chromatography

SH/T 1832-2020 异戊二烯橡胶微观结构的测定 核磁共振氢谱法

Determination of microstructure of isoprene rubber by proton nuclear magnetic resonance spectroscopy

SH/T 1830-2020 丙烯腈-丁二烯橡胶中壬基酚含量的测定 气相色谱-质谱法

Determination of nonylphenol content in acrylonitrile-butadiene rubber by gas chromatography-mass spectrometry

SH/T 1763-2020 氢化丁腈生橡胶（HNBR）中残留不饱和度的测定 碘值法

Determination of residual unsaturation in hydrogenated nitrile raw rubber (HNBR) iodine value method

SH/T 1814-2020 乙烯-丙烯共聚物（EPM）和乙烯-丙烯-二烯烃三元共聚物（EPDM）中钒含量的测定

Determination of vanadium content in ethylene-propylene copolymer (EPM) and ethylene-propylene-diene terpolymer (EPDM)

SH/T 1501-2019 合成橡胶胶乳干聚物制备

Synthetic rubber latex dry polymer preparation

JIS K 6250:2019 橡胶. 物理试验方法制备和调制试验片的通用方法

Rubber -- General procedures for preparing and conditioning test pieces for physical test methods

SH/T 1151.1-2019 合成橡胶胶乳 机械稳定性的测定 第1部分：高速法

Determination of mechanical stability of synthetic rubber latex Part 1: High speed method

ISO 1853:2018 硫化或热塑性导电橡胶和耗能橡胶.电阻率的测量

Conducting and dissipative rubbers, vulcanized or thermoplastic - Measurement of resistivity