共找到 179 条与 气动工具 相关的标准,共 12 页
Covers the following types: coal pick shanks, chisel shanks, rivet snap shanks - parallel and tapered, breaker and spade shanks, concrete breaker shanks and rock drill shanks. Designations for each type.
Specification for shanks for pneumatic tools and fitting dimensions of chuck bushings
This second edition cancels and replaces the first edition (1974). Specifies a test method and technical conditions for the supply of pneumatic tools and gives detailed instructions on the measurements of power output and air consumption and means of adjusting the measured values to specified conditions. A format for test report is included for rotary tools in annex A and in annex B for percussive tools. Annex C gives a procedure of impact energy.
Rotary and percussive pneumatic tools; performance tests
Applies to coal pick shanks, chisel shanks, rivet snap shanks (parallel or tapered), breaker and spade shanks, concrete breaker shanks and rock drill shanks. These types relate to the machine for which they are mainly designed, but this does not prevent the use of the shanks for other applications. ISO 1180 does not apply to pneumatic hammer and their chuck bushings but those features of chuck bushings (dimensions and tolerances) which ensure interchangeability are specified.
Shanks for pneumatic tools and fitting dimensions of chuck bushings
Test method for measurement of reaction torque and how such measurements should be evaluated.
Method of measurement for reaction torque and torque impulse from hand-held pneumatic assembly tools for installing threaded fasteners
Driving and spindle ends, for portable hand, air, and electric tools
Rotary pneumatic assembly tools for threaded fasteners; Performance test
Specifies a test method for tools and gives instructions on how measured data should be evaluated and presented. Is directly applicable to assembly torque control tools. In the case of stall type tools, only the reaction torque can be measured. Impacting, pulsing or ratcheting tools are not covered.
Hand-held pneumatic assembly tools for installing threaded fasteners; Reaction torque and torque impulse measurements
Operating elements (control devices) for pneumatic tools; terms, safety requirementsDiese Norm enth?lt sicherheitstechnische Festlegungen im Sinne des Gesetzes über technische Arbeitsmittel (GtA).
Operating elements (control devices) for pneumatic tools; terms, safety requirements
Pneumatic tools, prepared rivet snaps
Pneumatic tools, prepared rivet snaps
Pneumatic tools, shank chisels
Pneumatic tools, shank chisels
Pneumatic tools, shanks and bushings for riveting and chipping hammersZusammenhang mit ISO-Empfehlung ISO/R 1180—1970, siehe Erl?uterungen.
Pneumatic tools, shanks and bushings for riveting and chipping hammers
Pneumotic tools, transition nozzle tipsDie Cbergangstülle erm?glicht in Verbindung mit Kegeltülle A19 oder B19 nach DIN 20 034 den Obergang von lichter Schlauch weite 10,13 und 15 mm ouf lichte Schlauchweite 19 mm.
Pneumatic tools; transition nozzle tips
Pneumotic tools, cone nozzle tips, connection nuts, connection nipples
Pneumatic tools; cone nozzle tips, connection nuts, connection nipples
Pneumatic tools, sieves, sieve-nipples
Pneumatic tools, sieves, sieve-nipples
Pneumatic tools, rammer butts, cones for piston-rods
Pneumatic tools, rammer butts, cones for piston-rods
Pneumotic tools, screw nozzle tips
Pneumatic tools, screw nozzle tips
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号