L18 滤波器、延迟线 标准查询与下载

SANS 101952-1-1:2006 接入网络xDSL传输滤波器．第1部分：欧洲部署用ADSL分离器．第1子部分：使用POTS分离器（包括特殊xDSL变体专用附件）的DSL的低通部分的一般技术规范

Specifies requirements and test methods for the low pass part of DSL over POTS splitters.

Access network xDSL transmission filters Part 1: ADSL splitters for European deployment Sub-part 1: Generic specification of the low pass part of DSL over POTS splitters including dedicated annexes for specific xDSL variants

SANS 101952-1-4:2006 接入网络xDSL传输滤波器．第1部分：第1部分：欧洲配置的ADSL分路器．第4子部分：ISDN或POTS通用分路器上的ADSL规范

Specifies requirements and test methods for ADSL over "ISDN or POTS" universal splitters.

Access network xDSL transmission filters Part 1: ADSL splitters for European deployment Sub-part 4: Specification of ADSL over "ISDN or POTS" universal splitters

SJ 20962-2006 LJDT-176.5M、LJDT-186M、LJDT-372M型LC带通滤波器详细规范

本规范规定了LJDT-176.5M、LJDT-186M、LJDT-372M 型LC带通滤波器（以下简称滤波器）的详细要求。 本规范适用于航天、航空及地面通讯、遥控遥测系统中信号的带通滤波。

Detail specification for type LJDT-176.5M、LJDT-186M、LJDT-372M LC band pass filters

DLA DSCC-DWG-81022 REV C-2006 400赫兹的线路滤波器

This drawing describes the requirements for a 400 Hz, 115 V rms line filter designed to transmit 400 Hz with a 0.26 dB insertion loss, when the resistive load current equals 335 mA. The filter will attenuate frequencies above 420 Hz and below 380 Hz.

FILTER, LINE 400 HERTZ

ANSI/IEEE 1560:2005 100赫兹到10千兆赫范围内射频电力线路抗干扰滤波器的测量方法标准

Develops a standard method of measurement for evaluating the electromagnetic and radio frequency suppression capability of power-line filters in the frequency range of 100 Hz to 10 GHz. Applies to EMI/RFI filters in general (i.e., DC, single phase of poly phase systems rated for 600 V and below 1000 A). The method of measurement will describe general considerations, such as method of standardizing source impedance for nonlinear loads, temperature rise, attenuation measurement, components, and/or derating requirements when supplying non-sinusoidal load currents and operating in matched or mismatched impedance environments.

Standard for Methods of Measurement of Radio Frequency Power Line Interference Filter in the Range of 100 Hz to 10 GHz

SJ 20943-2005 针状无源干扰信号滤波器.抑制特性的测试方法

本规范规定了针状干扰信号滤波器抑制特性的测试方法。 本标准适用于单个针状信号滤波器抑制特性的测试。

Methods of measurement of the suppression characteristics of passive interference-free pin signal filters

DIN EN 61019-2:2006 表面声波(SAW)谐振器.第2部分:使用指南

This part of IEC 61019 gives practical guidance to the use of SAW resonators which are used in telecommunications, radio equipments and consumer products. IEC 61019-1 can be referred to for general information, standard values and test conditions.

Surface acoustic wave (SAW) resonators - Part 2: Guide to the use (IEC 61019-2:2005); German version EN 61019-2:2005

IEC 61338-1-4:2005 波导型介电谐振器.第1-4部分:一般信息和试验条件.毫米波频率时介电谐振器材料的相对复介电常数测量方法

This part of IEC 61338 describes the measurement method of dielectric properties for dielectric resonator materials at millimetre-wave frequency. This standard consists of two measurement methods: a) the dielectric rod resonator method excited by NRD-guide (Non-Radiative Dielectric waveguide) and b) the cut-off waveguide method excited by coaxial cables with small loops. a) The dielectric rod resonator method excited by NRD-guide is similar to the dielectric rod resonator method given in IEC 61338-1-3. This method has the following characteristics: - a complete and exact mathematical solution of complex permittivity is given by computer software; - the measurement error is less than 0,3 % for s' and less than 0,05 x 10-4 for tan 8; - the applicable measuring ranges of complex permittivity for this method are as follows: frequency: 30 GHz

Waveguide type dielectric resonators - Part 1-4: General information and test conditions - Measurement method of complex relative permittivity for dielectric resonator materials at millimetre-wave frequency

IEC 60939-2:2005/COR1:2005 抑制电磁干扰用无源滤波装置.第2部分:分规范.适用于安全试验的无源滤波装置.试验方法和一般要求.勘误1

This standard is Passive filter units for electromagnetic interference suppression - Part 2: Sectional specification: Passive filter units for which safety tests are appropriate - Test methods and general requirements; Corrigendum 1

Passive filter units for electromagnetic interference suppression - Part 2: Sectional specification: Passive filter units for which safety tests are appropriate - Test methods and general requirements; Corrigendum 1

IEC 60939-1/COR1:2005 抑制电磁干扰用无源滤波装置.第1部分:总规范.勘误1

This standard is Passive filter units for electromagnetic interference suppression - Part 1: Generic specification; Corrigendum 1

Passive filter units for electromagnetic interference suppression - Part 1: Generic specification; Corrigendum 1

BS EN 60939-1:2005 抑制电磁干扰用无源滤波装置.总规范

This generic specification relates to passive filter units for electromagnetic interference suppression for use within, or associated with, electronic or electrical equipment and machines. Both single- and multi-channel filters within one enclosure are included within the scope of this generic specification. Filters constructed of capacitive elements where the inductance is inherent in the construction of the filter are within the scope of this specification. Similarly, filters constructed of inductive elements where the capacitance is inherent in the construction of the filter are also within the scope of this generic specification. The manufacturer shall state whether a given component is to be designed as a capacitor, an inductor or a filter. The filter units within the scope of this generic specification are further distinguished as those for which safety tests are appropriate (e.g. those connected to mains supplies) and those for which such tests are not appropriate. A separate sectional specification covers the passive filter units for which safety tests are appropriate. This generic specification establishes standard terms, inspection procedures and methods of test for use in sectional and detail specifications within the IECQ-CECC system for electronic components.

Passive filter units for electromagnetic interference suppression - Part 1:Generic specification

NF C93-619-1-1:2005 总规范:使用波导型介电谐振器的滤波器

Generic specification : filters using waveguide type dielectric resonators.

NF C93-030-1:2005 抑制电磁干扰用无源滤波装置.第1部分:总规范

Passive filter units for electromagnetic interference suppression - Part 1 : generic specification.

DIN EN 60939-2-1:2005 抑制无线电干扰用整套滤波装置.第2-1部分:空白详细规范.抑制电磁干扰用无源过滤装置.要求安全试验的过滤器(评定等级D/DZ)

Complete filter units for radio interference suppression - Part 2-1: Blank detail specification - Passive filter units for electromagnetic interference suppression - Filters for which safety tests are required (assessment level D/DZ) (IEC 60939-2-1:2004);

DIN EN 60939-2-2:2005 抑制无线电干扰用整套滤波装置.第2-2部分:空白详细规范.抑制电磁干扰用无源过滤装置.要求安全试验的过滤器(只用于安全试验)

Complete filter units for radio interference suppression - Part 2-2: Blank detail specification - Passive filter units for electromagnetic interference suppression - Filters for which safety tests are required (Safety tests only) (IEC 60939-2-2:2004); Ger

DIN EN 61337-1:2005 采用波导型介电谐振器的滤波器.第1部分:通用规范

This part of IEC 61337 applies to filters using waveguide type dielectric resonators of assessed quality using either capability approval or qualification approval procedures.

Filters using waveguide type dielectric resonators - Part 1:Generic specification (IEC 61337-1:2004); German version EN 61337-1:2004

DIN EN 61019-1:2005 声表面波(SAW)谐振器.第1部分:通用规范

This part of IEC 61019 specifies the methods of test and general requirements for SAW resonators using either capability or qualification approval procedures of the IECQ system.

Surface acoustic wave (SAW) resonators - Part 1: Generic specification (IEC 61019-1:2004); German version EN 61019-1:2005

DIN EN 60368-1:2005 经质量评定的压电滤波器.第1部分:一般规范

This part of IEC 60368 specifies the methods of test and general requirements for piezoelectric filters of assessed quality using either capability approval or qualification approval procedures.

Piezoelectric filters of assessed quality - Part 1: Generic specification (IEC 60368-1:2000 + A1:2004); German version EN 60368-1:2000 + A1:2004

IEC 61338-4-1:2005 波导型介电谐振器 第4-1部分:空白详细规范

Is a blank detail specification and as such a supplementary document to the sectional specification IEC 61338-4. Contains requirements for the minimum content of detail specifications.

Waveguide type dielectric resonators - Part 4-1: Blank detail specification

IEC 61338-4:2005 波导型介电谐振器.第4部分:分规范

Applies to waveguide type dielectric resonators as custom built products or as standard catalogue items whose quality is assessed on the basis of capability approval. Prescribes the preferred ratings and characteristics with the appropriate tests and mea

Waveguide type dielectric resonators - Part 4: Sectional specification