M14 通信网传输系统接口 标准查询与下载

YD/T 2763-2014 2GHz cdma2000/CDMA 1X数字蜂窝移动通信网核心网网络优化系统功能技术要求

本标准规定了2GHz cdma2000/CDMA 1X数字蜂窝移动通信网核心网网络优化系统的功能，主要包括数据管理、拓扑管理、优化分析、日常监控等功能要求。本标准适用于2GHz cdma2000/CDMA 1X数字蜂窝移动通信网核心网网络优化系统。

Technical specification of general function for 2GHz cdma 2000/ CDMA 1X digital cell mobile communications core network optimization system

ETSI GS LTN 003-2014 低吞吐量网络（LTN）；协议和接口（V1.1.1）

Low Throughput Networks (LTN); Protocols and Interfaces (V1.1.1)

BS EN 62680-1:2013 数据和电源的通用串行总线接口. 通用串行总线规范,修订版本2.0

Universal serial bus interfaces for data and power. Universal serial bus specification, revision 2.0

YD/T 2615.3-2013 公众无线局域网网络管理 第3部分:接口技术要求

本部分规定了公众无线局域网(PWLAN)设备与PWLAN网络管理系统间的接口技术要求,包括接口功能要求、接口数据要求及相关处理机制。本部分适用于集中控制型接入点、独立控制型接入点及无线接入控制器设备的网络管理接口。

Network management technical requirements for public wireless LAN.part 3: Interface technical requirements

ITU-T Q.3301.1-2013 (预发布)1号资源控制协议第3版.业务控制协议实体和决策物理实体之间的Rs接口协议

This Recommendation provides the stage 3 specification of the protocol at the interface between service control entities (SCEs) and the policy decision physical entity (PD-PE). The functional requirements and the stage 2 specifications for this interface are contained in clause 8.1 of [ITU-T Y.2111] and in [b-ITU-T Q-Sup.51]. This interface is used to control session-based policy.

Resource control protocol No. 1, version 3 – Protocol at the Rs interface between service control entities and the policy decision physical entity (Study Group 11)

ITU-T Q.3303.3-2013 (预发布)3号资源控制协议.决策物理实体(PD-PE)和策略实施物理实体(PE-PE)之间的Rw接口协议:直径形态第三版

This Recommendation provides the stage 3 specification of the protocol at the interface between policy decision physical entities (PD-PE) and the policy enforcement physical entity (PE-PE). The functional requirements and the stage 2 specifications for this interface are contained in clause 9.2 of [ITU-T Y.2111] and in [ITU-T Q-Sup.51].

Resource control protocol No. 3 – Protocols at the Rw interface between a policy decision physical entity (PD-PE) and a policy enforcement physical entity (PE-PE): Diameter profile version 3 (Study Group 11)

YD/T 2336.4-2013 分组传送网（PTN）网络管理技术要求 第4部分：EMS-NMS接口通用信息模型

本部分规定了分组传送网络(PTN)网络管理体系中EMS-NMS接口的通用信息模型和功能。本部分适用于PTN网络管理系统。

Technical requirement for packet transport network management.Part 4: EMS-NMS interface common information model

ITU-R M.1801-2-2013 在低于6 GHz下运作的移动业务中包括移动及漫游应用的宽带无线访问系统的无线电接口标准

This Recommendation identifies specific radio interface standards for BWA systems in the mobile service operating below 6 GHz. The standards included in this Recommendation are capable of supporting users at broadband data rates, taking into account the ITU-R definitions of “wireless access” and “broadband wireless access” found in Recommendation ITU-R F.13992. This Recommendation is not intended to deal with the identification of suitable frequency bands for BWA systems, nor with any regulatory issues.

Radio interface standards for broadband wireless access systems, including mobile and nomadic applications, in the mobile service operating below 6 GHz

ANSI/ATIS 0900105.03-2013 同步光导网络(SONET).网络和设备接口信号的不稳定性

Synchronous Optical Network - (SONET) - Jitter Network Interfaces

ANSI/ATIS 0300247-2013 运行、管理、维护和保障系统(OAM&P).运行系统与网元间接口的性能管理功能区服务和信息模型

Operations, Administration, Maintenance, and Provisioning (OAM&P) - Performance Management Functional Area Services and Information Model for Interfaces between Operations Systems and Network Elements

ANSI/ATIS 0300208-2013 运转、管理、维护和供应(OAM&P).通信管理网络(TMN)接口(Q和X接口)用上层协议

Operations, Administration, Maintenance, and Provisioning (OAM&P) - Upper-Layer Protocols for Telecommunications Management Network (TMN) Interfaces, Q and X Interfaces

ANSI/SCTE 135-4-2013 DOCSIS 3.0.第4部分:运转支持系统接口

DOCSIS 3.0 Part 4: Operations Support Systems Interface

ANSI/TIA-4963-2013 可反转的平衡电压数字接口电路电特性

Electrical Characteristics of Reversible Balanced Voltage Digital Interface Circuits

BS ISO/IEC 24770:2012 信息技术. 实时定位系统 (RTLS) 设备的性能试验方法. 在2.4 GHz的空气接口通信的试验方法

Information technology. Real-time locating system (RTLS) device performance test methods. Test methods for air interface communication at 2,4 GHz

YD/T 627-2012 数字交换机数字中继接口(2 048Kbit/s)参数及数字中继接口间传输特性和测试方法

本标准规定了数字交换机进入通信网时,2048kbit/s数字中继接口应满足的参数,以及在一个交换机内数字中继接口应达到的传输特性指标,及相应的测试方法。本标准适用于各种A律PCM数字交换机。

Parameters,transmission characteristics and test methods of the digital relay interface (2048kbit/s) for digital switch

NF Z84-175-5:2012 数字加强式无线通讯系统(DECT);通用接口(CT).第5部分:网络层(NWK)(V2.4.1)

Digital Enhanced Cordless Telecommunications (DECT) - Common Interface (CI) - Part 5 : Network (NWK) layer (V2.4.1).

ITU-T Q.3304.2-2012 4号资源控制协议(远程文件拷贝rcp4)在运输资源控制物理实体和物理实体之间传输接口协议:简单网络管理协议(SNMP)RC替代研究组11

Recommendation ITU-T Q.3304.2 specifies the profile of a variant of the resource control protocol No.4 (rcp4) that uses the simple network management protocol (SNMP) at the Rc interface,i.e.,between the transport resource control physical entity (TRC-PE) and the transport physical entity (T-PE) in the resource and admission control functional block.This protocol operates across the Rc reference point,as defined in Recommendation ITU-T Y.2111.The interface is used for checking the network topology and resource status information of an access or a core network.

Resource control protocol No. 4 (rcp4) – Protocols at the Rc interface between a transport resource control physical entity and a transport physical entity: SNMP alternative (Study Group 11)

ITU-T Q.3303.1-2012 (预发布)资源控制协议第3协议在决策物理实体(PD-PE)和策略执行的物理实体(PE-PE)之间的接口:公共开放策略服务(COPS)替代

Recommendation ITU-T Q.3301.1 specifies the resource control protocol No.3 (rcp3) COPS profile at the Rw interface,i.e., between the policy decision physical entity (PD-PE) and the policy enforcement physical entity (PE-PE) in the resource and admission control function block. This protocol profile allows the final admission policy decisions to be installed (i.e., either push or pull mode) to a PE-PE from a PD-PE, supports resource control for both fixed and mobile networks and supports the network address port translation (NAPT) control and network address translation (NAT) traversal at PE-PEs as needed.It satisfies the requirements for information flows across the Rw reference point as specified in clause 9.2 of ITU-T Y.2111 and in Supplement 51 to the ITU-T Q-series.

Resource control protocol No. 3 – Protocol at the interface between a Policy Decision Physical Entity (PD-PE) and a Policy Enforcement Physical Entity (PE-PE): COPS alternative version 2 (Study Group 11)

ITU-T Q.3304.1-2012 4号资源控制协议(远程文件拷贝rcp4)协议在传输资源控制物理实体和传输物理实体之间的RC接口:公共开放策略服务(COPS)替代研究组11

Recommendation ITU-T Q.3304.1v2 provides the Stage 3 technical specifications for a protocol variant which uses the common open policy service (COPS) (described in IETF RFC 2748) to satisfy the requirements for information transfer across the Rc reference point,as defined in clause 9.3 of Recommendation ITU-T Y.2111.This protocol allows a transport resource control physical entity (TRC-PE) to collect network topology and resource status information from elements of an access or a core network.

Resource control protocol No. 4 (rcp4) – Protocols at the Rc interface between a transport resource control physical entity and a transport physical entity: COPS alternative (Study Group 11)

ITU-T M.3347-2012 通过网络管理系统和网元管理系统之间的接口激活下一代网络业务的要求.2号研究组

This Recommendation contains the requirements for the NGN service activation across the interface between the network management system (NMS) and the element management system (EMS) in the service provisioning business process. The requirements are provided using the telecommunications management network (TMN) interface specification methodology described in [ITU-T M.3020].

Requirements for the NGN service activation across the interface between the network management system and the element management system (Study Group 2)