Z15 大气环境有毒害物质分析方法 标准查询与下载

DIN EN 16339:2013 环境空气.利用散布式取样的二氧化氮浓度测定方法.德文版本EN 16339-2013

Ambient air - Method for the determination of the concentration of nitrogen dioxide by diffusive sampling; German version EN 16339:2013

NF X30-488*NF EN 16377:2013 废物描述.固体废物中溴化阻燃剂(BFR)的测定

Characterization of waste - Determination of brominated flame retardants (BFR) in solid waste

BS ISO 17091:2013 工作场所的空气. 氢氧化锂, 氢氧化钠, 氢氧化钾和氢氧化钙测定采用抑制型离子色谱法对相应阳离子的测量方法

Workplace air. Determination of lithium hydroxide, sodium hydroxide, potassium hydroxide and calcium dihydroxide. Method by measurement of corresponding cations by suppressed ion chromatography

JIS Z 8852:2013 烟气中粉尘浓度的连续测量方法

Methods of continuous measurement for dust concentration in flue gas

ISO 17091:2013 工作场所空气. 氢氧化锂, 氢氧化钠, 氢氧化钾以及氢氧化钙的测定. 通过抑制型离子色谱法测定相应阳离子的方法

This International Standard specifies a method for the determination of the time-weighted average mass concentration of lithium hydroxide (LiOH), sodium hydroxide (NaOH), potassium hydroxide (KOH),and calcium dihydroxide [Ca(OH)_2] in workplace air by collection of the particulate hydroxides on a filter and analysis of the corresponding cations using ion chromatography.

Workplace air.Determination of lithium hydroxide, sodium hydroxide,potassium hydroxide and calcium dihydroxide.Method by measurement of corresponding cations by suppressed ion chromatography

DIN EN 16253:2013 空气质量. 采用活性差分光学吸收光谱法(DOAS)的近地大气测量. 环境空气和漫发射测量; 德文版本EN 16253-2013

Air quality - Atmospheric measurements near ground with active Differential Optical Absorption Spectroscopy (DOAS) - Ambient air and diffuse emission measurements; German version EN 16253:2013

BS EN 16339:2013 环境空气. 扩散取样二氧化氮浓度的测定方法

Ambient air. Method for the determination of the concentration of nitrogen dioxide by diffusive sampling

JIS Z 8808:2013 测量烟气中尘埃浓度的方法

Methods of measuring dust concentration in flue gas

JIS Z 7152:2013 利用虚拟悬浮微粒取样器进行烟气中PM10/PM2.5质量浓度的测定

Determination of PM10/PM2.5 mass concentration in flue gas by use of virtual impactors

HJ 657-2013 空气和废气 颗粒物中铅等金属元素的测定 电感耦合等离子体质谱法

本标准规定了测定锑(Sb),铝(A1),砷(As),钡(Ba),铍(Be),镉(Cd),铬(Cr),钴(Co),铜(Cu),铅(Pb),锰(Mn),钼(Mo),镍(Ni),硒(Se),银(Ag),铊(Tl),钍(Th),铀(U),钒(V),锌(Zn),铋(Bi),锶(Sr),锡(Sn),锂(Li)等金属元素的电感耦合等离子体质谱法。本标准适用于环境空气PM、PM、TSP以及无组织排放和污染源废气颗粒物中的锑(Sb),铝(Al),砷(As),钡(Ba),铍(Be),镉(Cd),铬(Cr),钴(Co),铜(Cu),铅(Pb),锰(Mn),钼(Mo),镍(Ni),硒(Se),银(Ag),铊(Tl),钍(Th),铀(U),钒(V),锌(Zn),铋(Bi),锶(Sr),锡(Sn),锂(Li)等金属元素的测定。当空气采样量为150 m(标准状态),污染源废气采样量为0.600 m (标准状态干烟气)时,各金属元素的方法检出限见附录A。

Ambient air and stationary source emission.Determination of metals in ambient particulate matter.Inductively coupled plasma/mass spectrometry (ICP-MS)

NF X43-020*NF EN 16253:2013 空气质量.带活性差分吸收光谱法(DOAS)的近地大气探测.环境空气和漫射排放测量

Air quality - Atmospheric measurements near ground with active Differential Optical Absorption Spectroscopy (DOAS) - Ambient air and diffuse emission measurements

DIN CEN/TS 16450:2013 环境空气. 微粒物质浓度测量用自动化测量系统 (PM10; PM2.5); 德文版本CEN/TS 16450-2013

Ambient air - Automated measuring systems for the measurement of the concentration of particulate matter (PM10; PM2,5); German version CEN/TS 16450:2013

BS EN 16253:2013 空气质量. 采用活性差分光学吸收光谱法(DOAS)的近地大气测量. 环境空气和漫发射测量

Air quality. Atmospheric measurements near ground with active Differential Optical Absorption Spectroscopy (DOAS). Ambient air and diffuse emission measurements

HJ 656-2013 环境空气颗粒物（PM2.5）手工监测方法（重量法）技术规范

本标准规定了环境空气颗粒物(PM)手工监测方法(重量法)的采样、分析、数据处理、质量控制和质量保证等方面的技术要求。本标准适用于手工监测方法(重量法)对环境空气颗粒物(PM)进行监测的活动。

Technical specifications for gravimetric measurement methods for PM_2.5 in ambient air

HJ 655-2013 环境空气颗粒物（PM10和PM2.5）连续自动监测系统安装和验收技术规范

本标准规定了环境空气颗粒物(PM和PM)连续自动监测系统安装、调试、试运行和验收的技术要求。本标准适用于环境空气颗粒物(PM和PM)连续自动监测系统的安装和验收活动。

Technical specifications for installation and acceptance of ambient air quality continuous automated monitoring system for PM₁₀ and PM_2.5

EN 16253:2013 空气质量.带活性差分吸收光谱法(DOAS)的近地大气探测.环境空气和漫射排放测量

This European Standard describes the operation of active DOAS measuring systems with continuous radiation source, the calibration procedures and applications in determining gaseous constituents (e. g. NO2, SO2, O3, BTX, Hg) in ambient air or in diffuse emissions.

Air quality - Atmospheric measurements near ground with active Differential Optical Absorption Spectroscopy (DOAS) - Ambient air and diffuse emission measurements

EN 16339:2013 环境空气 扩散取样法测定二氧化氮浓度的方法

This European Standard specifies a method for the sampling and analysis of NO2 in ambient air using diffusive sampling followed by extraction and analysis by colorimetry or ion chromatography (IC). It can be used for the NO2 measurement in a concentration range of approximately 3 µg/m3 to 130 µg/m3. A sample is typically collected for a period of 1 to 4 weeks, with exposure periods depending on the design of the samplers and the concentration levels of NO2. Several sorbents can be used for trapping NO2 in ambient air using a diffusive sampler. This standard specifies the application of triethanolamine as the reagent. Nitrous acid and peroxyacetyl nitrate are the major chemical interferences of sorption by triethanolamine. However, in ambient air monitoring over long sampling times, both contaminants are generally present at low concentrations relative to NO2. Moreover, these species can also interfere with the measurement of NO2 when applying the EU reference method for NO2 monitoring based on chemiluminescence. This standard describes the application of a tube-type sampler with either a cylindrical or a slightly conical tube. Its typical uptake rate is about 1 cm 3 /min. Only for this sampler type sufficient evidence of validation has been found in a literature survey. The relative expanded uncertainty of NO2 measurements performed using these tube-type diffusive samplers can potentially be lower than 25 % for individual measurements. When aggregating results to form annual average values, the relative expanded uncertainty can be further reduced to levels below 15 % due to the reduction of random effects on uncertainty.

Ambient air - Method for the determination of the concentration of nitrogen dioxide by diffusive sampling

NF X30-424:2013 废物 通过钻孔恒水头渗透试验测定地面渗透系数

Déchets - Détermination du coefficient de perméabilité d'un terrain par essai d'infiltration à charge constante en forage

HJ 646-2013 环境空气和废气 气相和颗粒物中多环芳烃的测定 气相色谱-质谱法

本标准规定了测定环境空气和废气中十六种多环芳烃的气相色谱-质谱法。本标准适用于环境空气、固定污染源排气和无组织排放空气中气相和颗粒物中十六种多环芳烃(PAHs)的测定。十六种多环芳烃包括萘、苊烯、苊、芴、菲、蒽、荧蒽、芘、苯并[a]蒽、屈、苯并[b]荧蒽、苯并[k]荧蒽、苯并[a]芘、茚并[1,2,3-c,d]芘、二苯并[a,h]蒽、苯并[g,h,i]苝。若通过验证本标准也适用于其他多环芳烃的测定。当以100 L/min采集环境空气24 h时,采用全扫描方式测定,方法的检出限为0.000 4~0.000 9 μg/m,测定下限0.001 6~0.003 6 μg/m;当以225L/min采集环境空气24h时,采用全扫描方式测定,方法的检出限为0.000 2~0.000 4 μg/m,测定下限0.000 8~0.001 6 μ/m;当采集固定源废气1 m时,采用全扫描方式测定,方法的检出限为0.05~0.12 μg/m,测定下限0.20~0.48 μg/m。详见附表A。

Ambient air and stationary source emissions.Determination of gas and particle-phase polycyclic aromatic hydrocarbons with gas chromatography/mass spectrometry

HJ 647-2013 环境空气和废气 气相和颗粒物中多环芳烃的测定 高效液相色谱法

本标准规定了测定环境空气和废气中十六种多环芳烃的高效液相色谱法。本标准适用于环境空气、固定污染源排气和无组织排放空气中气相和颗粒物中十六种多环芳烃的测定。十六种多环芳烃(PAHs)包括:萘、苊烯、苊、芴、菲、蒽、荧蒽、芘、苯并[a]蒽、屈、苯并[b]荧蒽、苯并[k]荧蒽、苯并[a]芘、茚并[1,2,3-c,d]芘、二苯并[a,h]蒽、苯并[g,h,i]苝。若通过验证本标准也适用于其他多环芳烃的测定。当以100 L/min采集环境空气24 h时,方法的检出限为0.04~0.26ng/m,测定下限为0.16~1.04 ng/m;当采集固定源废气1 m时,方法的检出限为0.01~0.04 μg/m,测定下限为0.04~0.16 μg/m。详见附录A。

Ambient air and stationary source emissions.Determination of gas and particle-phase polycyclic aromatic hydrocarbons.High performance liquid chromatography