13.040.40 固定源排放限值 标准查询与下载
共找到 1179 条与 固定源排放限值 相关的标准，共 79 页
Gas and oil emission controls and limits at gas stations
- ICS
- 13.040.40
- CCS
- Z60
- 发布
- 2023-10-10
- 实施
- 2024-04-01
Oil and gas emission controls and limits from oil storage facilities
- ICS
- 13.040.40
- CCS
- Z64
- 发布
- 2023-10-10
- 实施
- 2024-04-01
Stationary source emissions - Determination of the mass concentration of sulfur dioxide in flue gases - Performance characteristics of automated measuring systems
- ICS
- 13.040.40
- CCS
- 发布
- 2023-10
- 实施
BS ISO 12141. Stationary source emissions. Determination of low range mass concentration of dust. Manual gravimetric method
- ICS
- 13.040.40
- CCS
- 发布
- 2023-09-27
- 实施
- 2023-09-27
Technical Specifications for Rapid Monitoring of Exhaust Particulate Matter from Stationary Pollution Sources
- ICS
- 13.040.40
- CCS
- Z 10
- 发布
- 2023-09-22
- 实施
- 2023-10-22
BS EN 14385. Stationary source emissions. Determination of the total emission of As, Cd, Cr, Co, Cu, Mn, Ni, Pb, Sb, Tl and V
- ICS
- 13.040.40
- CCS
- 发布
- 2023-09-06
- 实施
- 2023-09-06
Air pollutant emission standards for catering industry
- ICS
- 13.040.40
- CCS
- Z 60
- 发布
- 2023-09-01
- 实施
- 2023-12-01
Standard Practice for Collection of Floor Dust for Chemical Analysis
- ICS
- 13.040.40
- CCS
- 发布
- 2023-09-01
- 实施
本文件规定了分立器件生产过程污染物排放的术语和定义、总体要求、污染物产生、污染物排放控制、废物处理与回收利用、监督与报告、环保管理及培训与宣传等内容。
Discrete device production process pollutant emission specifications
- ICS
- 13.040.40
- CCS
- N772
- 发布
- 2023-08-11
- 实施
- 2023-08-20
Stationary source emissions — Sampling and determination of mercury in flue gas using chemical absorption method
- ICS
- 13.040.40
- CCS
- 发布
- 2023-08
- 实施
Stationary source emissions - Determination of low range mass concentration of dust - Manual gravimetric method
- ICS
- 13.040.40
- CCS
- 发布
- 2023-08
- 实施
本文件适用于海南省餐饮服务单位烹饪过程的大气污染物排放控制，也适用于产生油烟排放的食品制造企业大气污染物排放控制。 本文件不适用于居民家庭烹饪。
Air pollutant emission standards for catering industry
- ICS
- 13.040.40
- CCS
- Z60
- 发布
- 2023-07-06
- 实施
- 2023-10-31
本规程适用于山东省区域内房屋建筑施工现场和城市建筑
"Technical Regulations for the Prevention and Control of Dust in Housing Construction"
- ICS
- 13.040.40
- CCS
- Z60
- 发布
- 2023-07-03
- 实施
- 2023-08-01
本文件描述了固定污染源有组织排放废气中气态游离氯的离子色谱测定方法的原理、干扰和消除、试剂和材料、仪器和设备、样品、分析步骤、结果计算与表示、准确度、质量保证和质量控制等内容。 本文件适用于固定污染源有组织排放废气中氯气的测定。 当试样定容体积50.0 mL，进样量 25 μL 时，氯气的最低检出量为 1.80 μg，当采样体积为 60 L（标准状态）时，方法检出限为 0.03 mg/m3，测定下限为 0.12 mg/m3。
Determination of chlorine in waste gas from fixed pollution sources by ion chromatography
- ICS
- 13.040.40
- CCS
- Z 10
- 发布
- 2023-06-13
- 实施
- 2023-09-13
Determination of chlorine in waste gas from fixed pollution sources by ion chromatography
- ICS
- 13.040.40
- CCS
- Z 10
- 发布
- 2023-06-13
- 实施
- 2023-09-13
Technical requirements and detection methods for automatic monitoring system of ambient air gaseous pollutants (SO2, NO2, NO, O3, CO) sensor method
- ICS
- 13.040.40
- CCS
- Z10
- 发布
- 2023-06-13
- 实施
- 2023-09-13
Determination of chlorine in waste gas from fixed pollution sources by ion chromatography
- ICS
- 13.040.40
- CCS
- Z10
- 发布
- 2023-06-13
- 实施
- 2023-09-13
1 Scope This document specifies the requirements for the installation and on-going quality assurance and quality control of data acquisition and handling systems (DAHS). This includes requirements on: — installation (Clause 5); — quality assurance and quality control during QAL2 (Clause 6); — quality assurance and quality control during on-going operation (Clause 7); — annual functional test (Clause 8); — documentation (Clause 9). This document supports the requirements of EN 14181 and legislation such as the IED [1], MCPD [2] and E-PRTR [3]. It does not preclude the use of additional features and functions provided the minimum requirements of this document are met and that these features do not adversely affect data quality, clarity or access.
Stationary source emissions. Data acquisition and handling systems - Specification of requirements for the installation and on-going quality assurance and quality control of data acquisition and handling systems
- ICS
- 13.040.40
- CCS
- 发布
- 2023-05-31
- 实施
- 2023-05-31
This document specifies the following requirements: a) requirements for measurement sections and sites with respect to performing emission measurements; b) requirements for the measurement objective, plan and report of emission measurements of air pollutants and reference quantities to be carried out in waste gas ducts at industrial plants. This document applies to periodic measurements using manual or automated reference methods (RM). This document specifies generic principles which can be applied to perform emission measurements at different plant types and to meet different measurement objectives. NOTE The measurement objective is specified by the customer. The testing institute identifies the measurement objective and related regulatory requirements at the beginning of the measurement planning. Where measurements are being made for regulatory purposes, the customer should seek approval from the competent authority. This document specifies procedures for taking representative samples in waste gas ducts. This document specifies a procedure for finding the best available sampling point for automated measuring systems used for continuous monitoring of emissions. The planning and reporting aspects of this document are applicable to emission measurements at diffusive and fugitive emission sources. This document does not address aspects of structural safety of chimneys and ducts, construction of working platforms and safety of personnel using them.
Air quality — Measurement of stationary source emissions — Requirements for measurement sections and sites and for the measurement objective, plan and report
- ICS
- 13.040.40
- CCS
- 发布
- 2023-05-17
- 实施
Stationary source emissions — Determination of mass concentration of particulate matter (dust) at low concentrations — Manual gravimetric method
- ICS
- 13.040.40
- CCS
- 发布
- 2023-05
- 实施
