K74 灯具附件 标准查询与下载
共找到 1112 条与 灯具附件 相关的标准，共 75 页
A.C supplied electronic ballasts for tubular fluorescent lamps—General and safety requirements
- ICS
- 29.140
- CCS
- K74
- 发布
- 1994-07-07
- 实施
- 1995-01-01
本标准规定了管形荧光灯镇流器性能要求，试验方法，检验规则及标志、包装、运输、贮存等。 本标准适用于采用500V以下，50Hz交流电源供电的镇流器（不包括电阻型镇流器），它同其额定功率、尺寸和特性符合GB10682规定，带启动器或不带启动器的预热阴极型管形荧光灯相配套。本标准适用于完整的镇流器和它的各个组成部分，如电阻器、变压器和电容器。 注：有关60Hz交流电源镇流器和GB10682中未提供参数的灯所配用的镇流器，参见IEC81中技术参数，但性能要求必须符合本标准。
Ballasts for tubular fluorescent lamps Performance requirements
- ICS
- 29.140.30
- CCS
- K74
- 发布
- 1993-02-12
- 实施
- 1993-08-01
本标准等同采用国际标准IEC 920-1990《管形荧光灯用镇流器一般要求和安全要求》。 本标准论述了管形荧光灯镇流器的一般要求与安全要求；第一部分说明一般要求，第二部分为安全要求。对这类镇流器的性能要求见IEC 921标准（GB/T 14044）。 注：安全要求旨在保障凡按本标准制作的电气设备，在原定的使用场合中，并得到适当安装和维护的条件下，不致对人员、家畜以及财产造成危害。
Ballasts for tubular fluorescent lamps general and safety reduirements
- ICS
- 29.140
- CCS
- K74
- 发布
- 1993-02-04
- 实施
- 1993-08-01
本标准规定了管形荧光灯座和启动器座（以下分别简称为灯座和启座）的技术要求，试验方法及检验规则。用以保证荧光灯和启动器在座中的安全性和互换性。 本标准适用于防护等级为1P20的灯座和启座（高于该防护等级的座应参照GB7001的有关试验），用于无滴漏、无粉尘、无腐蚀性气体的场所。 本标准适用于GB13260中包括的灯座和启座，其他型式的座亦应参照使用。
Technical requiremnts of lampholders for tubular fluorescent lamps and starterholders
- ICS
- 29.140.30
- CCS
- K74
- 发布
- 1991-10-29
- 实施
本标准规定了检验管形荧光灯座和启动器座互换性尺寸和安全性的检验量规的型式尺寸和使用方法。 本标准适用于管形荧光灯座和启动器座检验量规的设计和制造。亦适用于各灯座生产单位的检验工作。
Gauges of lampholders for tubular fluorescent lamps and starterholders
- ICS
- 29.140.10
- CCS
- K74
- 发布
- 1991-10-29
- 实施
- 1992-08-01
本标准规定了工作电压不超过1000V的管形荧光灯（包括H形、环形和双D型）灯座和启动器座的型式和互换性尺寸。 本标准适用于按GB1312设计和制造的灯座和启动器座。
Typs and dimensions of lampholders for tubular fluorescent lamps and starterholdors
- ICS
- 29.140.10
- CCS
- K74
- 发布
- 1991-10-29
- 实施
- 1992-08-01
本标准规定了家用和类似用途照明开关产品的技术要求及相应的试验方法、检验规则。 本标准适用于室内照明器具和类似用途的小型固定电气装置用的手动开关（以下简称“开关”）。开关的最高工作电压不超过250V、额定电流不大于20A，使用环境温度不高于+40℃及不低于-35℃。开关用于无腐蚀和无爆炸气体及导电尘埃的室内或类似室内环境。 本标准不适用于电子开关、延时电子开关、延时开关、调光开关、防水与防溅型开关、以及带有过流保护的开关。
Household and similar use light switches
- ICS
- 29.140
- CCS
- K74
- 发布
- 1989-03-31
- 实施
- 1990-01-01
本标准适用于各种电光源上使用的插口式灯头.
Bayonet lamp caps--Types and dimensions
- ICS
- CCS
- K74
- 发布
- 1978-07-19
- 实施
- 1979-01-01
本标准适用于螺旋式及插口式白炽灯座（以下简称灯座）。
Types,fundamental parameters and dimensions of holders for incandescent lamps
- ICS
- 29.140.10
- CCS
- K74
- 发布
- 1967-03-04
- 实施
- 1968-01-01
本标准适用于山东省新建、改扩建智慧灯杆工程的规划、设计、施工和验收。
Construction Standards for Smart Light Pole Engineering
- ICS
- 29.140.40
- CCS
- K74
- 发布
- 2023-10-10
- 实施
- 2023-12-01
This standard contains Amendment 55 and 56 to IEC 60061-2, which covers the following standard sheets respectively systems 7005-13 – BA15, BA15-3(110°), BAU15, BAU15-3(110°), BAW15, BAW15-3(110°), BAY15, BAY15-3(110°), BAZ15, BAZ15-3(110°) 7005-80 – SV7, SV8.5, SVX8.5 7005-91 – W
Lamp caps and holders together with gauges for the control of interchangeability and safety - Part 2: Lampholders (IEC 60061-2:1969 + supplements A:1970 to S:1997 + A18:1998 to A57:2020, modified); German version EN 60061-2:1993 + A1:1995 to A7:1997 + A18
- ICS
- 29.140.10
- CCS
- K74
- 发布
- 2021-11-00
- 实施
- 2021-11-01
This standard contains Amendment 57 and 58 to IEC 60061-3, which covers the following standard sheets respectively systems: 7006-11 - B15, B22 7006-11B - BA15-3(110°), bAU15, BAU15-3(110°), BAW15, BAW15-3(110°), BA-15, BAY15-3(110°), BAZ15, BAZ15-3(110°) 7006-11C - BAZ15 7006-11D
Lamp caps and holders together with gauges for the control of interchangeability and safety - Part 3: Gauges (IEC 60061-3:1969 + supplements A:1970 to U:1997 + A20:1998 to A57:2020 + A58:2020, modified); German version EN 60061-3:1993 + A1:1995 to A7:1997
- ICS
- 29.140.10
- CCS
- K74
- 发布
- 2021-04-00
- 实施
This document specifies performance requirements for electronic controlgear for use on DC or AC supplies up to 1000 V (alternating current at 50 Hz or 60 Hz) and with an output frequency which can deviate from the supply frequency, associated with LED modules according to IEC 620
DC or AC supplied electronic controlgear for LED modules - Performance requirements (IEC 62384:2020); German version EN IEC 62384:2020
- ICS
- 29.140.99
- CCS
- K74
- 发布
- 2021-03-00
- 实施
- 2021-03-01
Remplacer le premier alinéa par le nouveau texte suivant:La présente partie de l'IEC 61347 spécifie les exigences générales et les exigences de sécurité pour les appareillages de lampes destinés à être utilisés sur des alimentations à courant continu jusqu'à 1 000 V et/ou sur des
Lamp controlgear - Part 1 : general and safety requirements
- ICS
- 29.140.30
- CCS
- K74
- 发布
- 2021-01-08
- 实施
- 2021-02-13
Miscellaneous lampholders - Part 2-3: Particular requirements - Lampholders for double-capped linear LED lamps
- ICS
- 29.140.10
- CCS
- K74
- 发布
- 2021
- 实施
Miscellaneous lampholders -- Part 1: General requirements and tests
- ICS
- 29.140.10
- CCS
- K74
- 发布
- 2019-03-20
- 实施
This international standart contains necessary requirements for G5/G13 lampholders, which are suitable for the direct connection across the mains without ballast.
Lampholders for tubular fluorescent lamps and starterholders (IEC 60400:2017); German version EN 60400:2017
- ICS
- 29.140.10
- CCS
- K74
- 发布
- 2018-06-01
- 实施
- 2018-06-01
This Standard applies to bayonet lampholders B15d and B22d for connection of lamps and semi-luminaires to a supply voltage of 250 V. This Standard also covers lampholders which are integral with a luminaire or intended to be built into appliances. It covers the requirements for the lampholder only.
Bayonet lampholders (IEC 61184:2017); German version EN 61184:2017
- ICS
- 29.140.10
- CCS
- K74
- 发布
- 2018-06-01
- 实施
- 2018-06-01
This part of IEC 61347 specifies particular safety requirements for electronic controlgear for use on AC supplies up to 1000 V at 50 Hz or 60 Hz and/or DC supplies with operating frequencies deviating from the supply frequency, associated with fluorescent induction lamps as specified in IEC 62532 and IEC 62639, for high-frequency operation. For emergency lighting operation, particular requirements for controlgear operated from a central supply are given in Annex J. Performance requirements appropriate to the safe operation of emergency lighting are also contained in Annex J. Requirements for emergency lighting controlgear operating from non-centralized power supplies are given in IEC 61347-2-7. NOTE Performance requirements detailed in Annex J are those considered to be safety related with respect to reliable emergency operation.
Lamp controlgear - Part 2-14: Particular requirements for DC and/or AC supplied electronic controlgear for fluorescent induction lamps
- ICS
- 29.140.99
- CCS
- K74
- 发布
- 2018-02-01
- 实施
- 2018-03-02
