87.060.30 溶剂 标准查询与下载

GB/T 1676-1981 增塑剂碘值的测定

本标准适用于环氧酯碘值的测定。

Determinating the iodine value of plasticizers

GB/T 1753-1979 稀释剂,防潮剂挥发性测定法

本标准适用于防潮剂及稀释剂挥发性能的测定。以其与乙醚挥发时间的比值表示。

Method of test for evaporation rate of thinners and anti-blushing agents

GB/T 1755-1979 稀释剂,防潮剂胶凝数测定法

本标准适用于涂料用稀释剂、防潮剂胶凝数的测定。在所用稀释剂、防潮剂的硝化棉或过氯乙烯树脂溶液中，逐渐滴入油漆溶剂油或无水乙醇，混匀，以硝化棉或过氯乙烯树脂析出时所用油漆溶剂油或无水乙醇的量，毫升数表示。

Methods of test for dilution ratio of thinners and anti-blushing agents

GB/T 1748-1979 腻子膜柔韧性测定法

本标准适用于腻子膜柔韧性的测定。将样板弯曲，观察腻子涂膜是否产生裂纹或脱落等现象，以弯曲圆弧的最小直径毫米表示。

Method of test for flexibility of putty coatings

GB/T 1749-1979 厚漆,腻子稠度测定法

本标准适用于厚漆或腻子稠度的测定。取定量体积试样，在固定压力下经过一定时间后，以试样流展扩散的直径表示。

Method of test for consistency of pastes and putties

GB/T 1752-1979 稀释剂,防潮剂白化性测定法

本标准适用于各种涂料用稀释剂和防潮剂白化性的测定，即用观察其对漆膜引起发白及失光的现象来评定结果。

Method for blushing test of thinners and anti-blushing agents

ASTM D6387-19(2023) 用毛细管气相色谱法测定松节油和相关萜烯产品成分的标准试验方法

Standard Test Methods for Composition of Turpentine and Related Terpene Products by Capillary Gas Chromatography

BS ISO 4626:2023 挥发性有机液体 原料有机溶剂沸程的测定

Volatile organic liquids. Determination of boiling range of organic solvents used as raw materials

ASTM D2942-02(2023) 卤化有机溶剂总酸接受度的标准试验方法（非回流法）

Standard Test Method for Total Acid Acceptance of Halogenated Organic Solvents (Nonreflux Methods)

ISO 4626:2023 挥发性有机液体 原料有机溶剂沸程的测定

Volatile organic liquids — Determination of boiling range of organic solvents used as raw materials

ASTM D365-23 可溶性硝化纤维素碱溶液标准指南

1.1 This guide covers the testing of soluble nitrocellulose base solutions that are made by dispersing various kinds and concentrations of soluble nitrocellulose (cellulose nitrate) in various solvent mixtures. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Section 11. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Guide for Soluble Nitrocellulose Base Solutions

GSO 2713:2023 油漆和清漆 脱漆剂

This standard relates to non-flammable fluid for the use in the removal of paint film from the wood and metallic surfaces prior to repainting. The paint remover can be brushed on to the painted surfaces, allowed to remain undisturbed until the paint film has become wrinkled or softened and subsequently removed, together with the residue to the paint film, by scrapping, followed by washing by water. Not recommended for aircraft, electronic and plastic equipments.

PAINTS AND VARNISHES - PAINT REMOVER

ISO/DIS 4626 挥发性有机液体 原料有机溶剂沸程的测定

Volatile organic liquids — Determination of boiling range of organic solvents used as raw materials

ISO/PRF 4626 挥发性有机液体 原料有机溶剂沸程的测定

Volatile organic liquids — Determination of boiling range of organic solvents used as raw materials

ASTM D233-13(2022) 松节油取样和试验的标准试验方法

1.1 These test methods cover procedures for sampling and testing turpentine, as defined by the Code of Federal Regulations and Terminology D804. These test methods are also used for the sampling and testing of pinenes, the major components of most turpentines. 1.2 These test methods primarily measure the physical rather than the chemical properties of turpentines and pinenes. As turpentines and pinenes are currently used chiefly as chemical raw materials for the production of resins and synthetic organic chemicals, chemical composition is also very important. Consequently, testing the chemical composition of turpentines and pinenes by gas chromatography has displaced these test methods to a large extent. (See for example Test Methods D6387.) 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Methods of Sampling and Testing Turpentine

ASTM D890-12(2022) 液态松树化学制品中水的标准试验方法

1.1 These test methods cover the quantitative determination of dissolved or occluded water present in any proportion in liquid pine chemicals, such as turpentine, pinene, dipentene, pine oil, tall oil, and tall oil fatty acids. Three methods of moisture testing are included. The Karl Fisher titration method is the preferred method for testing tall oil, Test Methods D803. 1.1.1 The Karl Fischer Titration method is based on the reaction between water and a complex reagent2 consisting of iodine, sulfur dioxide, pyridine, and methanol, whereby the iodine is converted to a colorless compound. The appearance of a persistent iodine color in the reaction mixture indicates the complete removal of free water by reaction with the reagent, and the endpoint may be measured colorimetrically. Automatic titrators find this endpoint by the restoration of a current strength when the resistance provided by the presence of water is eliminated. Amperometric automatic titrators find this endpoint by detecting the current flow that occurs once water is eliminated. 1.1.2 The coulometric titration method determines water content by electronic integration of a current sufficient to generate the precise amount of iodine from the required reagent to react with the water in the sample. 1.1.3 The azeotropic method utilizes the relatively low boiling point of water, as compared with other sample constituents, in a toluene or xylene matrix so that water is collected in a trap and measured. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Method for Water in Liquid Pine Chemicals

ASTM D801-02(2022) 双戊烯取样和试验的标准试验方法

1.1 These test methods cover procedures for sampling and testing dipentene and related terpene solvents, consisting chiefly of monocyclic terpene hydrocarbons distilling above the range for turpentine. 1.2 The procedures given in these test methods appear in the following order: Section Sampling 4 Detection and Removal of Separated Water 5 Appearance 6 Color 7 Odor 8 Specific Gravity 9 Refractive Index 10 Composition 11 Flash Point 12 Moisture 13 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard Test Methods for Sampling and Testing Dipentene

22/30452633 DC BS ISO 4626 挥发性有机液体 原料有机溶剂沸程的测定

BS ISO 4626. Volatile organic liquids. Determination of boiling range of organic solvents used as raw materials

KS M ISO 4626-2022 挥发性有机液体.用作原料的有机溶剂沸点范围的测定

Volatile organic liquids — Determination of boiling range of organic solvents used as raw materials

KS M ISO 4626:2022 挥发性有机液体.用作原料的有机溶剂沸点范围的测定

Volatile organic liquids — Determination of boiling range of organic solvents used as raw materials