87.060.30 溶剂 标准查询与下载

GSO ISO 4626:2008 挥发性有机液体 用作原料的有机溶剂沸程的测定

1.1 This International Standard specifies a method for determining the boiling range of liquids that boil between 30 and 300 “C at normal pressure, and that are chemically stable and do not torrode the apparatus during the disti I lation. 1.2 The method is applicable to organic liquids such as hydrocarbons, esters, alcohols, ketones, ethers and similar products. NOTE - The mthod differs from that described in ISO/R 918 with r-Pm to the volume of the distillation flask, the type of cooler and the distillation receiver.

Volatile organic liquids -- Determination of boiling range of organic solvents used as raw materials

ASTM D233-08 松脂的抽样和测试的标准试验方法

The test procedures described in this standard were developed when the chief use for turpentine was as a solvent. Currently however, the chief use for turpentine (and pinenes) is as raw materials for the production of resins and synthetic organic chemicals. Thus the chemical composition of turpentines and pinenes is extremely important and tests, in addition to the ones described in these test methods, are required in order to fully characterize turpentines and pinenes. The most widely used technique for determining the chemical composition of turpentines (and pinenes) is gas chromatography (see Test Methods D 6387).1.1 These test methods cover procedures for sampling and testing turpentine, as defined by the Code of Federal Regulations and Terminology D 804. These test methods are also used for the sampling and testing of pinenes, the major components of most turpentines. 1.2 These test methods primarily measure the physical rather than the chemical properties of turpentines and pinenes. As turpentines and pinenes are currently used chiefly as chemical raw materials for the production of resins and synthetic organic chemicals, chemical composition is also very important. Consequently, testing the chemical composition of turpentines and pinenes by gas chromatography has displaced these test methods to a large extent. (See for example Test Methods D 6387.) 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Methods of Sampling and Testing Turpentine

ASTM D3735-07 VMP石脑油的标准规范

1.1 This specification covers four types of moderately volatile hydrocarbon solvents, mainly aliphatic in composition and normally petroleum distillates. These solvents are used primarily by the coatings industry and are commonly referred to as VMP naphthas.1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.1.3 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded-off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.1.4 For specific hazard information and guidance, see the supplier's Material Safety Data Sheet for materials listed in this specification.

Standard Specification for VMP Naphthas

ASTM D4367-02(2007) 通过气相色谱法测定烃溶剂中苯的标准试验方法

Standard Test Method for Benzene in Hydrocarbon Solvents by Gas Chromatography

ASTM D1296-01(2007) 挥发性溶剂和稀释剂气味的标准测试方法

Standard Test Method for Odor of Volatile Solvents and Diluents

ASTM D4206-96(2007) 用小型开口杯装置持续燃烧液体混合物的标准试验方法

Standard Test Method for Sustained Burning of Liquid Mixtures Using the Small Scale Open-Cup Apparatus

DIN 53249:2007 涂料和清漆用溶剂.二戊烯.要求和试验方法

Solvents for paints and varnishes - Dipentene - Requirements and methods of test

ARMY QPL-680-3-2007 溶剂脱脂

This list has been prepared for use by or for the Government in the actheof products covered by the subject specification and such listing of a product is not intended to and does not connote endorsement of the product by the Department of Defense.

DEGREASING SOLVENT

DIN 55997 Berichtigung 1:2006 涂料和清漆用溶剂.去离子水.要求和试验方法.对 DIN 55997勘误

The standard specifies requirements for deionized water used for elektrodeposition paints, wayterthinnable paints (industrial finishes), waterthinnable binders and emulsion paints and describes the corresponding test methods.

Solvents for paints and varnishes - Deionized water - Requirements and methods of test, Corrigenda to DIN 55997

DIN 55689:2006 颜料和清漆用溶剂.丙烯乙二醇醚.纯度等级气相色谱分析测定

The process described is used for the gas chromatographic determination of the degree of purity of the following propylenglycolethers, which are used as solvents and thinners in paints and varnishes: Propylene glycol 1 methyl ether; Propylene glycol 1 ethyl ether; Propylene glycol 1 isopropyl ether; Propylene glycol 1 butyl ether; Propylene glycol 1 isobutyl ether; Propylene glycol 1 phenyl ether; Dipropylene glycol monomethyl ether.#,,#

Solvents for paints and varnishes - Propylene glycol ethers - Gas chromatographic determination of the degree of purity

DIN 55688:2006 颜料和清漆用溶剂.乙烯乙二醇醚.纯度等级气相色谱分析测定

Solvents for paints and varnishes - Ethylene glycol ethers - Gas chromatographic determination of the degree of purity

DIN 53248:2006 颜料和清漆用溶剂.松节油和木材松节油.要求和试验方法

The document describes requirements and test methods for gum spirit of turpentine and wood turpentine as solvent for paints and varnishes.

Solvents for paints and varnishes - Gum spirit of turpentine and wood turpentines - Requirements and methods of test

DIN 55686:2006 油漆和清漆用溶剂.醋酸酯.气体色谱法测定纯度

Solvents for paints and varnishes - Acetic esters - Gas chromatographic determination of the degree of purity

DLA MIL-PRF-11090 H (1)-2006 脱脂分离保护洗涤溶剂

This specification covers one class of degreasing and depreserving cleaning compound suitable for use in removing oils, greases, asphalt, tars, and rust preventive compounds, other than wax type, from metallic and painted surfaces.

CLEANING COMPOUND, DEGREASING AND DEPRESERVING SOLVENT

TIS 468-2007 色漆和清漆用石油溶剂油

White spirit for paint and varnish

ARMY MIL-PRF-680 B-2006 脱脂溶剂

This specification covers degreasing solvent that consists of four types ofpetroleum distillates.

DEGREASING SOLVENT

ASTM D4941-06(2010) 画家用膏状颜料消耗品制备的标准操作规程

Quality standards for artists'' paints require the evaluation of various appearance characteristics of paint films. Tinting strength determination (Test Method D4838) specifically requires the preparation of drawdowns for colorimetric measurement. Other evaluations such as color designation, transparency, gloss, and color difference measurements also require drawdown samples. Artists'' tube paints have a paste consistency that makes the use of traditional film application methods difficult, especially for drying oil paints. Artists'' paints vary in two properties important to the preparation of films, that is, transparency and drying time. Colorimetric determination and some other types of evaluation require paint specimens that completely hide the substrate. Very transparent paints require such a thick film to produce complete hiding that drying times is excessively long or the specimen surface is blemished. When complete hiding is necessary, this practice is designed to provide opaque films without these defects through application of a series of thin films.1.1 This practice covers the production of uniform films of artists'' tube paints and other nonflowing pigmented paints using paint applicators designed for less viscous paints. 1.2 Information on how to achieve opaque specimens from these paints is included. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Preparing Drawdowns of Artists' Paste Paints

ASTM D4941-06(2016) 艺术家粘贴涂料的制备提取标准实施规程

5.1 Quality standards for artists' paints require the evaluation of various appearance characteristics of paint films. Tinting strength determination (Test Method D4838) specifically requires the preparation of drawdowns for colorimetric measurement. Other evaluations such as color designation, transparency, gloss, and color difference measurements also require drawdown samples. 5.2 Artists’ tube paints have a paste consistency that makes the use of traditional film application methods difficult, especially for drying oil paints. 5.3 Artists' paints vary in two properties important to the preparation of films, that is, transparency and drying time. Colorimetric determination and some other types of evaluation require paint specimens that completely hide the substrate. Very transparent paints require such a thick film to produce complete hiding that drying times is excessively long or the specimen surface is blemished. When complete hiding is necessary, this practice is designed to provide opaque films without these defects through application of a series of thin films. 1.1 This practice covers the production of uniform films of artists’ tube paints and other nonflowing pigmented paints using paint applicators designed for less viscous paints. 1.2 Information on how to achieve opaque specimens from these paints is included. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Preparing Drawdowns of Artists&x2019; Paste Paints

DLA MIL-PRF-6864 E-2005 冷油器洗涤溶剂

This specification covers one type of oil cooler solvent-type cleaning compound. The oil cooler cleaning compound solvent described herein is intended for cleaning either copper or aluminum-alloy aircraft oil coolers.

CLEANING COMPOUND, SOLVENT, OIL COOLER

CNS 2361-2005 珂王罗玎（工业级）

本标准适用于以乙醇(Ethyl Alcohol)与乙醚(Ethyl Ether)之混合液溶解硝化纤维素而制成，用于照相材料等之工业级珂王罗 王定 (Collodion)，以原料硝化纤维素之质量，硝化度之差异，含量，溶剂之配合率，可供各种不同性质之用途。

Collodion for industrial use