共找到 152 条与 焦炭 相关的标准,共 11 页
本标准规定了焦炭全硫含量测定的方法提要、试剂和材料、仪器设备、试验步骤、试验结果的计算和精密度。 本标准适用于焦炭全硫含量的测定,方法一为艾氏卡法,方法二为高温燃烧法(快速法),方法一为仲裁法。
Coke--Determination of total sulphur
本标准规定了测定焦炭水分、灰分、挥发分、固定碳的方法提要、试验仪器和设备、试验步骤、试验结果的计算及精密度。 本标准适用于焦炭水分、灰分、挥发分、固定碳的测定。
Coke--Determination of proximate analysis
本标准适用于铸造焦、冶金焦等焦炭的真相对密度的测定。
Coke--Determination of true relative density
本标准适用于铸造焦、冶金焦等焦炭假相对密度及总气孔率的测定。
Coke--Determination of apparent relative density and total porosity
本标准适用于铸造焦、冶金焦等焦炭的显气孔率的测定。
Coke--Determination of show porosity
Microscopic analysis method of coke pore structure and raw coal lithofacies
This document specifies a method for determining the strength of coke by the shatter test.
Coke - Determination of shatter indices
This document specifies a method for the determination of the bulk density of coke in a cubical or cylindrical container of small capacity (0,2 m3). It is applicable to coke with a nominal top size not greater than 125 mm.
Coke - Determination of bulk density in a small container
This document specifies procedures for the size analysis of coke by manual and/or low impact mechanical sieving, using square or round holed sieves of aperture sizes between 125 mm and 0,5 mm. Guidance on handling the sampling and sizing of coke products greater than 125 mm is given in Annex A.
Coke - Size analysis by sieving
Determination of ammonium thiocyanate content in coke oven gas desulfurization waste liquid by spectrophotometry
Clean production standard semi-coke industry
This document specifies a method for the determination of the particle size distribution of a sample of coke having a typical size distribution as normally produced by calcination of delayed petroleum coke. The same procedure is applicable to consignments of calcined anthracite. This document does not apply to fractions of carbon material prepared by sieving and crushing or to filter fines. This method is applicable to the determination of particle sizes ranging from 0,25 mm to 16 mm, as the sum of the percentages of the size distribution above and below this range is typically less than 10 %. This document does not apply to determining particle sizes below 0,25 mm where a specific test for dust is used.
Carbonaceous materials used in the production of aluminium - Calcined coke - Determination of particle size distribution
Coke - Determination of coke reactivity index (CRI) and coke strength after reaction (CSR)
Method for determination of optical structure of coke
Coke powder and small particle coke
本标准规定了焦炭机械采样、制样、在线粒度分析及机械强度测定的技术要求。 本标准适用于干熄焦生产线,湿熄焦生产线可参照使用。对于焦炭机械采制样、粒度分析及机械强度测定的集成系统只要符合本规范所述的基本原则,其系统的具体构成、工艺流程、采用形式可以多种多样。
The technical specification of online automatic sampling, sample preparation, particle size analysis and the determination of mechanical strength for coke
Technical Specifications for Small Coke Ovens for Coking Tests
Carbonaceous materials for the production of aluminium. Calcined coke for electrodes. Determination of the electrical resistivity of granules
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号