K42 电力电容器 标准查询与下载

DL/T 5292-2013 1000kV交流输变电工程系统调试规程

本标准适用于1000kV交流输变电工程的系统调试,当1000kV交流输变电工程使用可控高压电抗器、固定/可控串联补偿装置等设备时,则应视相应工程技术规范要求,增加相应的试验项目。本标准规定了1000kV交流输变电工程系统调试的项目、要求及评价依据,当本标准与国家法律、行政法规的规定相抵触时,应按照国家法律、行政法规的规定执行。

Code of system commissioning for 1000kV AC transmission and transformation project

DL/T 1220-2013 串联电容器补偿装置 交接试验及验收规范

本标准规定了串联电容器补偿装置(简称串补装置)现场交接试验应遵循的基本原则、试验项目、验收标准等。本标准适用于220kV~500kV电压等级的串联电容器补偿装置,其他电压等级可参照执行。

Code for hand-over tests of series capacitor installation

IEC 60143-2:2012 电力系统用串联电容器.第2部分:串联电容组用保护设备

Series capacitors for power systems - Part 2: Protective equipment for series capacitor banks

NB/T 41003-2011 标称电压1000V及以下交流电力系统用自愈式并联电容器产品质量分等

Product quality classification of self-healing shunt capacitors for AC power systems with nominal voltage 1000V and below

NB/T 41001-2011 电容式电压互感器产品质量分等

Capacitive voltage transformer product quality classification

IEC 60358-1:2012 耦合电容器及电容分压器. 第1部分: 通用条款

This part of IEC 60358 applies to: • Capacitors, with rated voltage > 1 000 V, connected line to ground with the low voltage terminal either permanently earthed or connected to devices, for applications listed hereunder and other similar uses. This standard serves as basic standard for the coupling capacitor, the different parts of this standard will present the supplementary specifications and tests, for example IEC 60358-2, IEC 60358-3 or IEC 60358-4.

Coupling capacitors and capacitor dividers - Part 1: Common clauses

IEEE 18-2012 并联电力电容器用电气电子工程师学会(IEEE)标准

IEEE Standard for Shunt Power Capacitors

KS C 4621-2011 工业接地故障断路器

이 표준은 주접점이 회로에 접속되며 지락보호에 사용하는, 정격전압이 교류 380 V 이하,

Residual current operated circuit-breaker with integral overcurrent protection for household uses(RCBO)

JB/T 1811-2011 压缩气体标准电容器

本标准规定了压缩气体标准电容器的适用范围、术语和定义、使用条件、质量要求和试验、标志、包装和运输等。 本标准适用于内部以压缩气体为电介质的、主要用于50 Hz（或60 Hz）高压测量电路中的标准电容器（以下简称电容器）。

Compressed gas standard capacitors

JB/T 7115-2011 低压电动机就地无功补偿装置

本标准规定了低压电动机就地无功补偿装置的术语和定义、使用条件、设计、结构及安全要求、质量要求和试验、标志、运输及安装运行导则等。 本标准适用于频率为50 Hz或60 Hz、标称电压为1 kV及以下的交流配电系统，与电动机并联使用，用以补偿电动机所产生的感性无功，提高功率因数的就地无功补偿装置（以下简称“装置”）。

Local reactive power compensation installations for a low-voltage motor

DIN EN 60252-1:2011 AC电动机电容.第1部分:总则.性能,测试和等级评定.安全要求.安装和操作指南(IEC 60252-1-2010);德文版本EN 60252-1-2011

AC motor capacitors - Part 1: General - Performance, testing and rating - Safety requirements - Guidance for installation and operation (IEC 60252-1:2010); German version EN 60252-1:2011

DIN EN 60143-4:2011 电力系统用串联电容器.第4部分:晶闸管控制串联电容器(IEC 60143-4-2010);德文版本EN 60143-4-2010

Series capacitors for power systems - Part 4: Thyristor controlled series capacitors (IEC 60143-4:2010); German version EN 60143-4:2010

DIN EN 61881-1:2011 轨道交通.铁道车辆设备.电力电子设备用电容器.第1部分:纸/塑料膜电容器(IEC 61881-1-2010);德文版本EN 61881-1-2011

Railway applications - Rolling stock equipment - Capacitors for power electronics - Part 1: Paper/plastic film capacitors (IEC 61881-1:2010); German version EN 61881-1:2011

BS EN 60252-1:2011 交流电动机用电容器.总则.性能,试验和额定值.安全性要求.安装和操作指南

This part of IEC 60252 applies to motor capacitors intended for connection to windings of asynchronous motors supplied from a single-phase system having a frequency up to and including 100 Hz, and to capacitors to be connected to three-phase asynchronous motors so that these motors may be supplied from a single-phase system. This standard covers impregnated or unimpregnated capacitors having a dielectric of paper, plastic film, or a combination of both, either metallized or with metal-foil electrodes, with rated voltages up to and including 660 V. Motor start capacitors are covered by IEC 60252-2. NOTE The following are excluded from this standard: – shunt capacitors of the self-healing type for a.c. power systems of up to and including 1 000 V nominal voltage (see IEC 60831-1); – shunt capacitors of non-self-healing type for a.c. power systems of up to and including 1 000 V nominal voltage (see IEC 60931-1); – shunt capacitors for a.c. power systems having a nominal voltage above 1 000 V (see IEC 60871-1); – capacitors for induction heat-generating plants, operating at frequencies between 40 Hz and 24 000 Hz (see IEC 60110-1); – series capacitors (see IEC 60143); – coupling capacitors and capacitor dividers (see IEC 60358); – capacitors to be used in power electronic circuits (see IEC 61071); – small a.c. capacitors to be used for fluorescent and discharge lamps (see IEC 61048); – capacitors for suppression of radio interference (IEC publication under consideration); – capacitors intended to be used in various types of electrical equipment and thus considered as components; – capacitors intended for use with d.c. voltage superimposed on a.c. voltage. The object of this standard is a) to formulate uniform rules regarding performance, testing and rating; b) to formulate specific safety rules; c) to provide a guidance for installation and operation.

AC motor capacitors. General. Performance, testing and rating. Safety requirements. Guidance for installation and operation

BS EN 60252-2:2011 交流电动机电容器.电动机起动电容器

This part of IEC 60252 applies to motor start capacitors intended for connection to windings of asynchronous motors supplied from a single-phase system having the frequency of the mains. This standard covers impregnated or unimpregnated metallized motor start capacitors having a dielectric of paper or plastic film, or a combination of both and electrolytic motor start capacitors with non-solid electrolyte, with rated voltages up to and including 660 V.

AC motor capacitors. Motor start capacitors

DL/T 355-2010 滤波器及并联电容器装置检修导则

本标准规定了换流站交直流滤波器及并联电容器装置检修的基本要求、检修周期、检修项目、检修内容及检修过程等方面要求。 本标准适用于电力行业换流站交直流滤波器及并联电容器装置的检修工作。

Guide for maintenance of filters and shunt capacitors

JIS C 4902-3 ERRATUM 1:2010 勘误表

ERRATUM

IEC 60143-4:2010 电力系统用串联电容器.第4部分:可控硅控制的的串联电容器

This part of IEC 60143 specifies testing of thyristor controlled series capacitor (TCSC) installations used in series with transmission lines. This standard also addresses issues that consider ratings for TCSC thyristor valve assemblies, capacitors, and reactors as well as TCSC control characteristics, protective features, cooling system and system operation.

Series capacitors for power systems - Part 4: Thyristor controlled series capacitors

IEC 60252-1:2010 交流电动机电容器.第1部分:总则.性能,试验和评定.安全性要求.安装和运转指南

This part of IEC 60252 applies to motor capacitors intended for connection to windings of asynchronous motors supplied from a single-phase system having a frequency up to and including 100 Hz, and to capacitors to be connected to three-phase asynchronous motors so that these motors may be supplied from a single-phase system. This standard covers impregnated or unimpregnated capacitors having a dielectric of paper, plastic film, or a combination of both, either metallized or with metal-foil electrodes, with rated voltages up to and including 660 V. Motor start capacitors are covered by IEC 60252-2. The object of this standard is a) to formulate uniform rules regarding performance, testing and rating; b) to formulate specific safety rules; c) to provide a guidance for installation and operation.

AC motor capacitors - Part 1: General - Performance, testing and rating - Safety requirements - Guidance for installation and operation

DL/T 366-2010 串联电容器补偿装置一次设备预防性试验规程

本标准规定了串联电容器补偿装置(简称串补装置)一次设备的预防性试验项目、要求和方法。 本标准适用于220kV-500kV电压等级输电线路串补装置一次设备的预防性试验,其他电压等级的串补装置一次设备可参照执行。

Preventive test code for primary equipment of series capacitor installation