K42 电力电容器 标准查询与下载

DL/T 366-2010 串联电容器补偿装置一次设备预防性试验规程

本标准规定了串联电容器补偿装置(简称串补装置)一次设备的预防性试验项目、要求和方法。 本标准适用于220kV-500kV电压等级输电线路串补装置一次设备的预防性试验,其他电压等级的串补装置一次设备可参照执行。

Preventive test code for primary equipment of series capacitor installation

JB/T 10932-2010 低压电力滤波装置

本标准规定了低压电力滤波装置的术语和定义、试验方法、检验规则、产品标志及出厂文件、铭牌的基本内容，包装、运输和贮存的基本要求等。 本标准适用于工频50Hz，额定电压不超过1000V的低压配电系统中。由滤波电容器和滤波电抗器及电阻器(如果需要)等器件组成的谐波回路，以吸收、滤除系统特定谐波次数谐波电流的电力滤波装置。

Low-voltage power harmonic filters

JB/T 11051-2010 电力电容器用双轴定向聚丙烯薄膜技术条件

本标准规定了电力电容器介质用双轴定向聚丙烯薄膜的产品分类和命名、一般要求、尺寸、性能、试验方法、检验规则、标志、包装、运输和贮存等。 本标准适用于电力电容器介质用双轴定向聚丙烯薄膜。 本标准不适用于金属化介质用薄膜。

Technical specification of biaxially oriented polypropylene films for power capacitors

JB/T 10931-2010 高压电力滤波装置

本标准规定了高压电力滤波装置的术语和定义、使用条件、技术性能要求、结构和导体要求、安全要求、质量要求和试验、标志、包装等。 本标准适用于并联连接在交流额定频率为50 Hz、标称电压为l kV以上电力系统中，用来滤除特定的谐波电流，以减少电网电压波形畸变，改善电能质量和功率因数的高压电力滤波装置(以下简称滤波装置)。

High-voltage power harmonic filters

JB/T 11052-2010 电容器用压嵌式绝缘套管技术条件

本标准规定了电容器用压嵌式绝缘套管的术语和定义、运行环境条件、质量要求和试验、包装、运输、贮存、验收与安装。 本标准适用于电力电容器介质用双轴定向聚丙烯薄膜。 本标准不适用于交流高压电力电容器用压嵌式绝缘套管，其他类型的电容器用套管也可参考本标准。

Technical specification of planish inlay insulated bushings for capacitors

JIS C 4902-1:2010 高压电力电容器及附属仪器.第1部分:电容器

High voltage power capacitors and attached apparatus -- Part 1: Capacitors

JIS C 4902-3:2010 高压电力电容器及附属仪器.第3部分:放电线圈

High voltage power capacitors and attached apparatus -- Part 3: Discharge coils

DL/T 653-2009 高压并联电容器用放电线圈使用技术条件

Specification of discharge coils for high voltage shunt capacitor for order

DL/T 604-2009 高压并联电容器装置使用技术条件

本标准规定了电力行业使用的高压并联电容器装置的术语、产品分类、技术要求、安全要求、试验方法、检验规则等。 本标准适用于电力系统中35kV及以上电压等级变电站（所）内安装在6kV～66kV侧的高压并联电容器装置和10kV（含6kV）配电线路上的柱上高压并联电容器装置。

Technical specification of high-volatage shunt capacitor installations

BS EN 61071:2007 电力电容器

This International Standard applies to capacitors for power electronics applications. The operating frequency of the systems in which these capacitors are used is usually up to 15kHz, while the pulse frequencies may be up to 5 to 10 times the operating frequency. The standard distinguishes between a.c. and d.c. capacitors which are considered as components when mounted in enclosures. This standard covers an extremely wide range of capacitor technologies for numerous applications, e.g. overvoltage protection, d.c. and a.c. filtering, switching circuits, d.c. energy storage, auxiliary inverters, etc. The following are excluded from this standard: – capacitors for induction heat-generating plants operating at frequencies between 40 Hz and 24 000 Hz (see IEC 60110-1 and IEC 60110-2); – capacitors for motor applications and the like (see IEC 60252-1 and IEC 60252 -2); – capacitors to be used in circuits for blocking one or more harmonics in power supply networks; – small a.c. capacitors as used for fluorescent and discharge lamps (see IEC 61048 and IEC 61049); – capacitors for suppression of radio interference (see IEC 60384-14); – shunt capacitors for a.c. power systems having a rated voltage above 1 000 V (see IEC 60871-1 and IEC 60871-2); – shunt power capacitors of the self-healing type for a.c. systems having a rated voltage up to and including 1 000 V (see IEC 60831-1 and IEC 60831-2); – shunt power capacitor of the non-self-healing type for a.c. systems having a rated voltage up to and including 1 000 V (see IEC 60931-1 and IEC 60931-2); – electronic capacitors not used in power circuits; – series capacitors for power systems (see IEC 60143); – coupling capacitors and capacitors dividers (see IEC 60358); – capacitors for microwave ovens (see IEC 61270-1); – capacitors for railway applications (see IEC 61881). Examples of applications are given in Clause 9.1.

Capacitors for power electronics

DIN EN 61071:2008 电力电容器

Capacitors for power electronics (IEC 61071:2007); German version EN 61071:2007

JIS C 4908:2007 电气设备用电容器

この規格は，主として電気機器に組み込んで使用するコンデンサのうち，商用周波数における定格電圧が単相交流1000V以下のもので，次に示すものについて規定する。

Capacitors for electrical apparatus

KS C 9205-2007 电辐射加热器

이 규격은 정격 전압 단상 교류 220 V, 정격 주파수는 60Hz, 정격 입력이 2 kW

Electric radiant heaters

KS C 9309-2007 电水壶

이 규격은 단상 교류로서 정격 전압 300 V 이하, 정격 입력 1.5 kW 이하의 용기와

Electric pots

KS C 9310-2007 电饭锅

이 규격은 단상 교류로서 정격 전압 300 V 이하, 정격 입력 2 kW 이하의 주로 가정

Electric rice-cookers

IEC 61071:2007 电力电容器

This International Standard applies to capacitors for power electronics applications. The operating frequency of the systems in which these capacitors are used is usually up to 15kHz, while the pulse frequencies may be up to 5 to 10 times the operating frequency. The standard distinguishes between a.c. and d.c. capacitors which are considered as components when mounted in enclosures. This standard covers an extremely wide range of capacitor technologies for numerous applications, e.g. overvoltage protection, d.c. and a.c. filtering, switching circuits, d.c. energy storage, auxiliary inverters, etc. The following are excluded from this standard: - capacitors for induction heat-generating plants operating at frequencies between 40 Hz and 24 000 Hz (see IEC 60110-1 and IEC 60110-2); - capacitors for motor applications and the like (see IEC 60252-1 and IEC 60252 -2); - capacitors to be used in circuits for blocking one or more harmonics in power supply networks; - small a.c. capacitors as used for fluorescent and discharge lamps (see IEC 61048 and IEC 61049); - capacitors for suppression of radio interference (see IEC 60384-14); - shunt capacitors for a.c. power systems having a rated voltage above 1 000 V (see IEC 60871-1 and IEC 60871-2); - shunt power capacitors of the self-healing type for a.c. systems having a rated voltage up to and including 1 000 V (see IEC 60831-1 and IEC 60831-2); - shunt power capacitor of the non-self-healing type for a.c. systems having a rated voltage up to and including 1 000 V (see IEC 60931-1 and IEC 60931-2); - electronic capacitors not used in power circuits; - series capacitors for power systems (see IEC 60143); - coupling capacitors and capacitors dividers (see IEC 60358); - capacitors for microwave ovens (see IEC 61270-1); - capacitors for railway applications (see IEC 61881). Examples of applications are given in Clause 9.1.

Capacitors for power electronics

JB/T 10676-2006 金属化安全膜交流电动机电容器

本标准规定了金属化安全膜交流电动机电容器的适用范围、术语、使用条件、技术要求、试验方法、检验规划、安全要求、标志、安装和运行导则等。 本标准适用于频率100Hz及以下的单相系统供电的异步电动机绕组连接的，以及和三相异步电动机连接从而使这些电动机可由单相系统来供电的金属化安全膜交流电动机电容器（以下简称电容器）。这种电容器是浸渍的或不浸渍的塑料薄膜作介质，具有安全防爆结构的金属化电极，其额定电压为660V及以下。（具体内容见纸本标准）

Metallized safety film AC motor capacitor

KS C 9201-2006 电熨斗

이 규격은 단상 교류 정격 전압 300 V 이하인 것으로 정격 소비 전력이 100 W를 초

Electric irons

JB/T 10557-2006 高压无功就地补偿装置

本标准规定了高压无功就地补偿装置的适用范围、术语、产品分类、技术要求、试验方法、检验规则、标志、包装、贮存和运输等。 本标准适用于并联连接于频率50Hz或60Hz、标称电压3kV～10kV的三相交流配电系统，与电功机并联使用，用以补偿电动机感性五功，提高功率因数的无功就地补偿装置（简称“装置”）。 本标准的目的是： a)阐述关于性能、试验和定额的统一规则； b)阐述特殊的安全规则； c)提供安装和运行说明。

High voltage local power factor correction installations

JB/T 10558-2006 柱上式高压无功补偿装置

本标准规定了柱上式高压无功补偿装置的适用范围、术语、使用条件、技术要求、试验方法、检验规则和标志等。 本标准适用于并联连接于频率50Hz、标称电压6kV或10kV的三相交流电力线路中，用来改善功率因数、调整网络电压、降低线路损耗的柱上式压无功补偿装置（以下简称“装置”）。包括固定接入装置、手动（人工）投切装置和自动投切装置。 本标准的目的是： a)阐述关于性能、试验和定额的统一规则； b)阐述特殊的安全规则； c)提供安装和运行导则。

Pole mounted high-voltage power factor correction installations