L25 继电器、斩波器 标准查询与下载

IEC 60255-26:2004 电气继电器.第26部分:量度继电器和保护装置的电磁兼容性要求

Specifies the requirements for electromagnetic compatibility for measuring relays and protection equipment. Is applicable to measuring relays and protection equipment for power system protection, including the control, monitoring and process interface eq

Electrical relays - Part 26: Electromagnetic compatibility requirements for measuring relays and protection equipment

ANSI/IEEE C37.93:2004 电话信道上可听音电源系统保护继电器应用指南

Contains information and recommendations for applying audio tones over voice grade channels for power system relaying.

Guide for Power System Protective Relay Applications of Audio Tones over Telephone Channels

DLA MS24184 REV M (1)-2004 非密封I型 1 PST(N.O.)300安培电磁继电器

Dimensions are in inches.

RELAYS, ELECTROMAGNETIC, 300 AMPERES, 1 PST (N.O.), TYPE I, WITH AUXILIARY CONTACTS, HERMETICALLY SEALED

DLA MS25395 REV J (1)-2004 I型2 PDT,5安培火箭安装密封电磁继电器

This specification is approved for use by all Departments and Agencies of the Department of Defense.

RELAYS, ELECTROMAGNETIC, 5 AMPERES, 2 PDT, TYPE I, HERMETICALLY SEALED

DLA MS24143 REV X (1)-2004 密封I型 3 PST(N.O.)25安培电磁继电器

Dimensions are in inches.

RELAYS, ELECTROMAGNETIC, 3 PST (N.O.), 25 AMPERES, TYPE I, HERMETICALLY SEALED

DLA MIL-PRF-32140-2004 建立性能最佳性电频电磁继电器 常规

The General Services Administration has authorized the use of this commercial item description as a replacement for Military Specifications MIL-V-16720E and MIL-V-16721D which are cancelled.

RELAYS, ELECTROMAGNETIC, RADIO FREQUENCY, ESTABLISHED RELIABILITY, GENERAL SPECIFICATION FOR

DLA QPL-5757-100-2004 电磁继电器.一般规格

This list has been prepared for use by or for the Government in the acquisition of products covered by Specification MIL-R-5757. Listing of a product is not intended to and does not connote endorsement of the product by the Department of Defense. All products listed herein have been qualified under the requirements for the product as specified in the latest effective issue of the applicable specification. This list is subject to change without notice; revision or amendment of this list will be issued as necessary. The listing of a product does not release the supplier from compliance with the specification requirements.

RELAYS, ELECTROMAGNETIC, GENERAL SPECIFICATION FOR

DLA MS24171 REV G (1)-2004 非密封II型 1 PST(N.O.)200安培电磁继电器

Dimensions are in inches.

RELAYS, ELECTROMAGNETIC, 200 AMPERES, 1 PST (N.O.), TYPE II, NONHERMETICALLY SEALED

DLA QPL-28776-35-2004 混合继电器确定可靠性一般规格

This list has been prepared for use by or for the Government in the acquisition of products covered by Specification MIL-PRF-28776. Listing of a product is not intended to and does not connote endorsement of the product by the Department of Defense.

RELAYS, HYBRID, ESTABLISHED RELIABILITY, GENERAL SPECIFICATION FOR

DLA MS24172 REV J (1)-2004 非密封III型 1 PST(N.O.)200安培电磁继电器

Referenced Government documents of the issue listed in that issue of the Department of Defense Index of Specifications and Standards (DODISS) specified in the solicitation form a part of this specification to the extent specified herein.

RELAYS, ELECTROMAGNETIC, 200 AMPERES, 1 PST (N.O.), TYPE III, NONHERMETICALLY SEALED

DLA MS25271 REV J (1)-2004 I型4 PDT,10安培焊锡钩密封电磁继电器

1/ Dimensions are in inches. 2/ Metric equivalents are given for general information only. 3/ Unless otherwise specified, tolerance is ±.010 (0.25 mm). 4/ Terminal numbers need not appear on relay header provided there is affixed to the relay a suitable legible circuit diagram that permanently and positively identifies each terminal location specified herein. 5/ In the event of conflict between the text of this specification and the references cited herein, the text of this specification shall take precedence. 6/ Referenced Government documents of the issue listed in that issue of the Department of Defense Index of Specifications and Standards (DoDISS) specified in the solicitation forms a part of this specification to the extent specified herein.

RELAYS, ELECTROMAGNETIC, 10 AMPERES, 4 PDT, TYPE I, SOLDER HOOK, HERMETICALLY SEALED

DLA MS24140 REV M (1)-2004 密封I型 1 PST(N.O.)50安培电磁继电器

Dimensions are in inches.

RELAYS, ELECTROMAGNETIC, 50 AMPERES, 1 PST (N.O.), TYPE I, HERMETICALLY SEALED

DLA MS24178 REV H (2)-2004 非密封II型 2 PST(N.O.)55安培电磁继电器

Dimensions are in inches. Metric equivalents are given for general information. Unless otherwise specified, tolerances are ±.031 inch (0.79 mm). Additional flat washer may be used for terminal seat. Part No. MS24178-D1 replaces part No. MS24178-1. For design feature purposes, this specification takes precedence over procurement documents referenced herein. Referenced Government documents of the issue listed in Assist Online (http://assist.daps.dla.mil) or Assist Quick Search (http://assist.daps.dla.mil/quicksearch) specified in the solicitation form a part of this specification to the extent specified herein. Cadmium or cadmium compounds are prohibited on external hardware. Spring washer on drawing is a spring lock washer.

RELAYS, ELECTROMAGNETIC, 55 AMPERES, 2PST, (N.O.) TYPE II, NONHERMETICALLY SEALED

NF C45-255-55:2003 机电式有或无继电器.第55部分:空白详细规范.经质量评定的机电式有或无电信继电器.11 mm X 5.5 mm (最大)基座的双转换触点

Le présent document fournit une spécification particulière cadre pour les relais électromécaniques (de tout ou rien télécom), soumis au régime d'assurance de la qualité, à deux contacts à deux directions et de surface d'encombrement de 11 mm x 7,5 mm (max.).

Electromechanical all-or-nothing relays - Part 55 : blank detail specification - Electromechanical all-or-nothing telecom relays of assessed quality - Two change-over contacts, 11 mm x 7,5 mm (max.) base.

NF C45-255-10:2003 经质量评定的机电式单元继电器.第10部分:分规范.工业用继电器

Le présent document fournit une spécification intermédiaire, applicable aux relais élémentaires électromécaniques (de tout ou rien à temps non spécifié), soumis au régime d'assurance de la qualité et destiné aux applications industrielles.

Electromechanical elementary relays of assessed quality - Part 10 : sectional specification - Relays for industrial application.

NF C45-255-11:2003 经质量评估的机电式单元继电器.第11部分:空白详细规范.工业用继电器

Le présent document fournit une spécification particulière cadre, applicable aux relais élémentaires électromécaniques (de tout ou rien à temps non spécifié), soumis au régime d'assurance de la qualité et destiné aux applications industrielles.

Electromechanical elementary relays of assessed quality - Part 11 : blank detail specification - Relays for industrial application.

NF C45-255-51:2003 机电式有或无继电器.第51部分:空白详细规范.经质量评定的机电式有或无电信继电器.非标准类型和结构

Le présent document fournit une spécification particulière cadre pour les relais électromécaniques (de tout ou rien télécom) soumis au régime d'assurance de la qualité, de types et construction non normalisés.

Electromechanical all-or-nothing relays - Part 51 : blank detail specification - Electromechanical all-or-nothing telecom relays of assessed quality - Non-standardized types and construction.

NF C45-255-50:2003 机电式有或无继电器.第50部分:分规范.经质量评定的机电式有或无电信继电器

Le présent document fournit une spécification intermédiaire pour les relais électromécaniques (de tout ou rien télécom), soumis au régime d'assurance de la qualité.

Electromechanical all-or-nothing relays - Part 50 : sectional specification - Electromechanical all-or-nothing telecom relays of assessed quality.

NF C45-255-53:2003 机电式有或无继电器.第53部分:空白详细规范.经质量评估的机电式有或无电信继电器.14 mm X 9 mm 底座的双转换触点

Le présent document fournit une spécification particulière cadre pour les relais électromécaniques (de tout ou rien télécom), soumis au régime d'assurance de la qualité, à deux contacts à deux directions et de surface d'encombrement de 14 mm x 9 mm.

Electromechanical all-or-nothing relays - Part 53 : blank detail specification -Electromechanical all-or-nothing telecom relays of assessed quality - Two change-over contacts, 14 mm x 9 mm base.

NF C45-255-52:2003 机电式有或无继电器.第52部分:空白详细规范.经质量评估的机电式有或无电信继电器.20 mm X 10 mm 底座的双转换触点

Le présent document fournit une spécification particulière cadre pour les relais électromécaniques (de tout ou rien télécom), soumis au régime d'assurance de la qualité, à deux contacts à deux directions et de surface d'encombrement de 20 mm x 10 mm.

Electromechanical all-or-nothing relays - Part 52 : blank detail specification - Electromechanical all-or-nothing telecom relays of assessed quality - Two change-over contacts, 20 mm x 10 mm base.