G52 涂料辅助材料 标准查询与下载

BS EN 15336:2007 粘合剂.静负荷状态下胶粘件断裂时间的测定

This European Standard describes a procedure for the determination of the time to failure of a bonded joint, using a specimen which is statically loaded under specified conditions. This method can only be used for comparing adhesives, and the results cannot be used for design purposes.

Adhesives - Determination of the time to rupture of bonded joints under static load

BS EN ISO 7143:2007 涂料和清漆用粘合剂.表征水基粘合剂特征用试验方法

This International Standard specifies methods of test for characterizing binders, i.e. aqueous dispersions and solutions of polymers and copolymers, in particular those used as raw materials for water-based coating materials. The properties determined will depend on whether a drying or curing system is tested.

Binders for Paints and varnishes - Methods of test for characterizing water-based binders

ISO 7143:2007 色漆、清漆和粘合剂.表征水基层粘合剂的试验方法

This International Standard specifies methods of test for characterizing binders, i.e. aqueous dispersions and solutions of polymers and copolymers, in particular those used as raw materials for water-based coating materials. The properties determined will depend on whether a drying or curing system is tested.

Binders for paints and varnishes - Methods of test for characterizing water-based binders

ISO 11909:2007 色漆和清漆用粘合剂.聚亚安酯树脂.通用试验方法

This International Standard details general test methods for polyisocyanate resins and solutions of polyisocyanate resins intended for use as binders in paints, varnishes and related products.

Binders for paints and varnishes - Polyisocyanate resins - General methods of test

ISO 7142:2007 色漆和清漆用粘合剂.环氧树脂.通用试验方法

This International Standard specifies general methods of test for epoxy resins for use in paints, varnishes and similar products. It is also applicable to those solutions made from epoxy resins that are intended for use as binders for paints and varnishes. The test methods to be applied to an individual epoxy resin shall be the subject of agreement between the interested parties. The test methods described in this International Standard are not intended for epoxy esters (see Note to 3.1).

Binders for paints and varnishes - Epoxy resins - General methods of test

ASTM D1617-07 溶剂和稀释剂酯化值的标准试验方法

This test method is useful in determining the assay of solvents and thinners which are esters or solutions of esters of carboxylic acid. The ester value is calculated as percent ester. This test method has its greatest application where the solvent or thinner is not a pure ester. This test method may be used in assessing compliance to specification.1.1 This test method covers the determination of the ester value of solvents and thinners used in lacquers and other coatings.1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.1.3 For purposes of determining conformance of an observed or a calculated value using this test method to relevant specifications, test result(s) shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 8.6.1.4 For hazard information and guidance, see the supplier's Material Safety Data Sheet.

Standard Test Method for Ester Value of Solvents and Thinners

ASTM D4209-07(2013) 纤维素、乳化液、树脂溶液、虫漆和清漆的挥发物和非挥发物含量的测定用标准操作规程

4.1 The nonvolatile content of raw materials may be used to determine the total nonvolatile content (solids) of paint and related coatings. Such information may be useful to coatings producers and users for the determination of the total solids available for film formation and for the estimation of the volatile organic content. 1.1 This practice is intended to serve as a guide to the selection of the proper ASTM test method for determining the volatile and nonvolatile content of cellulosics, emulsions, resin solutions, shellac, and varnishes. Note 1—Standards for determining the composition of the volatile fraction are not covered by this practice. 1.2 The standards referenced in the practice are as follows: Classification Section ASTM Standard Cellulosics 5.1 D871     D914     D1347 Emulsions 5.2 D2369 Resin Solutions 5.3 D1259  

Standard Practice for Determining Volatile and Nonvolatile Content of Cellulosics, Emulsions, Resin Solutions, Shellac, and Varnishes

ASTM D600-07(2012) 液体涂料催干剂的标准规格

1.1 This specification covers liquids for use in paints, varnishes, enamels, and similar organic coatings and are solutions of metallic salts of: 1.1.1 Class A???2-Ethyl hexanoic acids in petroleum spirits. 1.1.2 Class B???Naphthenic acids in petroleum spirits. 1.1.3 Class C???Neodecanoic acids in petroleum spirits. 1.1.4 Class D???Tall oil fatty acids in petroleum spirits. 1.1.5 Class E???Any of the above acids or acid blends, but containing additives that make the liquid drier water dispersible. Some other driers may also contain complexing agents. 1.1.6 Class F???Other acids and acid blends unidentified by their producers. 1.2 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off ???to the nearest unit??? in the last right-hand digit used in expressing the specification limit in accordance with the rounding-off method of Practice E29. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 For specific hazard information and guidance, see the supplier's Material Safety Data Sheets for materials listed in this specification.

Standard Specification for Liquid Paint Driers

ASTM D4140-07 干燥剂、干性油、松脂制品和溶剂挥发物含量和不挥发物含量测定标准指南

The nonvolatile content of raw materials may be used to determine the total nonvolatile content (solids) of paint and related coatings. Such information may be useful to coatings producers and users for the determination of the total solids available for film formation and for the estimation of the volatile organic content.1.1 This guide is intended to aid in the selection of the proper ASTM test method for determining the volatile and nonvolatile content of driers, drying oils, naval stores, and solvents. Note 1Test methods for determining the composition of the volatile fraction are not covered by this guide. 1.2 The test methods included are as follows:StandardSectionASTM Designation Driers D 1644Drying oils D 555D 1960Naval stores D 233D 889D 1131Solvents D 1353

Standard Guide for Determining Volatile and Nonvolatile Content of Driers, Drying Oils, Naval Stores, and Solvents

ASTM D1617-07(2012) 溶剂和稀释剂酯化值的标准试验方法

1.1 This test method covers the determination of the ester value of solvents and thinners used in lacquers and other coatings. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 For purposes of determining conformance of an observed or a calculated value using this test method to relevant specifications, test result(s) shall be rounded off ???to the nearest unit??? in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 8.6. 1.5 For hazard information and guidance, see the supplier's Material Safety Data Sheet.

Standard Test Method for Ester Value of Solvents and Thinners

DIN 55997 Berichtigung 1:2006 涂料和清漆用溶剂.去离子水.要求和试验方法.对 DIN 55997勘误

The standard specifies requirements for deionized water used for elektrodeposition paints, wayterthinnable paints (industrial finishes), waterthinnable binders and emulsion paints and describes the corresponding test methods.

Solvents for paints and varnishes - Deionized water - Requirements and methods of test, Corrigenda to DIN 55997

DIN EN ISO 2114 Corrigendum 1:2006 塑料制品（聚酯树脂）和涂料清漆（粘合剂）. 局部和全部酸值的测定（ISO 2114: 2000）; 英文版本DIN EN ISO 2114: 2002-06勘误表1

Plastics(polyester resins) and paints and varnishes (binders) - Determination of parial acid value and total acid value (ISO 2114:2000) Corrigendum 1 to English version of DIN EN ISO 2114:2002-06

DIN 55688:2006 颜料和清漆用溶剂.乙烯乙二醇醚.纯度等级气相色谱分析测定

Solvents for paints and varnishes - Ethylene glycol ethers - Gas chromatographic determination of the degree of purity

DIN 55689:2006 颜料和清漆用溶剂.丙烯乙二醇醚.纯度等级气相色谱分析测定

The process described is used for the gas chromatographic determination of the degree of purity of the following propylenglycolethers, which are used as solvents and thinners in paints and varnishes: Propylene glycol 1 methyl ether; Propylene glycol 1 ethyl ether; Propylene glycol 1 isopropyl ether; Propylene glycol 1 butyl ether; Propylene glycol 1 isobutyl ether; Propylene glycol 1 phenyl ether; Dipropylene glycol monomethyl ether.#,,#

Solvents for paints and varnishes - Propylene glycol ethers - Gas chromatographic determination of the degree of purity

DIN 53248:2006 颜料和清漆用溶剂.松节油和木材松节油.要求和试验方法

The document describes requirements and test methods for gum spirit of turpentine and wood turpentine as solvent for paints and varnishes.

Solvents for paints and varnishes - Gum spirit of turpentine and wood turpentines - Requirements and methods of test

DIN 55686:2006 油漆和清漆用溶剂.醋酸酯.气体色谱法测定纯度

Solvents for paints and varnishes - Acetic esters - Gas chromatographic determination of the degree of purity

DIN EN ISO 15715:2006 涂料和清漆用粘合剂.浑浊度的测定(ISO 15715-2003)

The standard specifies a method for instrumental determining the turbidity of clear liquids. It is applicable to resins and resin solutions, solvents, clear coating materials, monomers, and other liquids where clarity is specified.

Binders for paints and varnishes - Determination of turbidity (ISO 15715:2003); English version of DIN EN ISO 15715:2006-05

NF T30-410-1:2006 色漆和清漆用粘合剂.软化点的测定.第1部分:环-球法

Binders for paints and varnishes - Determination of softening point - Part 1 : ring-and-ball method.

BS EN ISO 150:2006 涂料和清漆用生的、精制的和熟的亚麻籽油.规范和试验方法

This International Standard specifies the requirements and the corresponding methods of test for raw, refined and boiled linseed oils for paints and varnishes.

Raw, refined and boiled linseed oil for paints and varnishes - Specifications and methods of test

BS ISO 150:2006 色漆和清漆用生的、精制的和熟的亚麻仁油.规范和试验方法

This International Standard specifies the requirements and the corresponding methods of test for raw, refined and boiled linseed oils for paints and varnishes.

Raw, refined and boiled linseed oil for paints and varnishes - Specifications and methods of test