L17 电感器、变压器 标准查询与下载

IEC 61869-5:2011 互感器.第5部分:电容电压互感器附加要求

Instrument transformers - Part 5: Additional requirements for capacitor voltage transformers

IEEE Std C57.16-2011 干式空心系列连接电抗器的要求、术语和试验规范

Requirements, Terminology, and Test Code for Dry-Type Air-Core Series-Connected Reactors

SJ/T 10021.3-2010 电子设备用固定电感器 第3部分：分规范 射频绕线电感器

Fixed inductors for electronic equipment Part 3: Sectional specification for radio frequency wirewound inductors

SJ/T 10021.3.1-2010 电子设备用固定电感器 第3-1部分：空白详细规范 射频绕线电感器 评定水平E

Fixed inductors for electronic equipment Part 3-1: Blank detail specification for radio frequency wirewound inductors assessment level E

ANSI/UL 1876-2011 电子设备用隔离信号和反馈变压器用安全性标准

The requirements of UL 1876 cover isolating signal and feedback transformers for use in electronic equipment where only audio, video, and other signal waveforms are transformed. These transformers are intended to provide isolation from circuits that are either conductively connected to a branch circuit supply or connected to secondary circuits involving voltages that are considered to present a risk of electric shock by the nature of their use in an end-product.

Standard For Safety For Isolating Signal and Feedback Transformers for Use in Electronic Equipment

ANSI/UL 1411-2011 用于视听设备和电视设备的变压器和电机变压器安全标准

The requirements for UL 1411 cover transformers, autotransformers, and motor-transformers intended for use in audio-, radio-, and television-type appliances in which the primary winding is connected across the supply circuit.

Standard for Safety for Transformers and Motor Transformers for Use in Audio-, Radio-, and Television-Type Appliances

JJG 313-2010 测量用电流互感器检定规程

本规程适用于额定频率为 50 Hz(或 60 Hz)的0.001级-0.5级的测量用电流互感器(以下简称为电流互感器)的首次检定、后续检定和使用中检验。

Verification Regulation of Instrument Current Transformers

JJG 314-2010 测量用电压互感器检定规程

本规程适用于额定频率为 50 Hz(或 60 Hz)的0.001级-0.5级的测量用电压互感器(以下简称为电压互感器)的首次检定、后续检定和使用中检验。

Verification Regulation of Instrument Voltage Transformers

JJG 169-2010 互感器校验仪检定规程

本规程适用于采用差值法原理、工作频率为50 Hz、测量电流互感器和电压互感器比例误差的互感器校验仪(以下简称校验仪)的首次检定、后续检定和使用中检验。

Verification Regulation of Transformers Test Set

DIN EN 61869-1:2010 仪表变压器.第1部分:一般要求(IEC 61869-1-2007,修改).德文版本EN 61869-1-2009

This International Standard is applicable to newly manufactured instrument transformers with analogue or digital output for use with electrical measuring instruments or electrical protective devices having rated fequencies from 15 Hz to 100 Hz. This standard is a product familiy standard and covers general requirements only. For each kind of instrument transformer the product standard is composed by this standard and the relevant specific standard.

Instrument transformers - Part 1: General requirements (IEC 61869-1:2007, modified); German version EN 61869-1:2009

BS EN 61869-1:2009 仪表用变压器.一般要求

This International Standard is applicable to newly manufactured instrument transformers with analogue or digital output for use with electrical measuring instruments or electrical protective devices having rated frequencies from 15 Hz to 100 Hz. This standard is a product family standard and covers general requirements only. For each kind of instrument transformer the product standard is composed by this standard and the relevant specific standard.

Instrument transformers - General requirements

ANSI/IEEE C37.110/Cor 1:2010 保护继电器用电流变压器的应用IEEE指南.技术勘误1:对方程式18和19的更正

This guide describes the characteristics and classification of current transformers (CTs) used for protective relaying. It also describes the conditions that cause the CT output to be distorted and the effects on relaying systems of this distortion. The selection and application of CTs for the more common protection schemes are also addressed.

IEEE Guide for the Application of Current Transformers Used for Protective Relaying Purposes - Corrigendum 1: Corrections to Equation 18 and Equation 19

IEEE Std C37.110/COR 1-2010 用于保护继电器的电流互感器应用指南.勘误表1:等式18和等式19的更正

Guide for the Application of Current Transformers Used for Protective Relaying Purposes Corrigendum 1: Corrections to Equation 18 and Equation 19

JIS C 1736-1 ERRATUM 1:2009 勘误表

ERRATUM

DIN EN 62024-2:2009 高频感应元器件.电气特性和测量方法.第2部分:DC对DC变流器的感应额定电流(IEC 62024-2:2008),德文版本EN 62024-2:2009

High frequency inductive components - Electrical characteristics and measuring methods - Part 2: Rated current of inductors for DC to DC converters (IEC 62024-2:2008); German version EN 62024-2:2009

JIS C 5064:2009 应用在电子及通讯设备中的固定电感器.标记代码

This Standard specifies marking codes for fixed inductors for use in electronic and telecommunication equipment.

Fixed inductors for use in electronic and telecommunication equipment -- Marking codes

JIS C 1736-1:2009 计量设备用仪器变压器.第1部分:一般测量仪器

This Standard specifies the induction transformers for metering service used in combination with a watt-hour meter, a var-hour meter or a maximum demand watthour meter.

Instrument transformers for metering service -- Part 1: General measuring instrument

JIS C 1736-2:2009 计量设备用仪表变压器.第2部分:交易或认证用测量仪器

This Standard specifies the induction transformers for metering service used in combination with a watt-hour meter, a var-hour meter or a maximum demand watt-hour meter,which is used in the measurement on transaction or certification.

Instrument transformers for metering service -- Part 2: Measuring instruments used in transaction or certification

ISO 16063-21:2003/Cor 1:2009 振动和冲击传感器校准方法.第21部分:与参考传感器进行比对的振动校准.技术勘误1

Methods for the calibration of vibration and shock transducers - Part 21: Vibration calibration by comparison to a reference transducer; Technical Corrigendum 1

BS EN 62024-2:2009 高频感应元件.电气特性和测量方法.直流对直流变流器用感应器的额定电流

High frequency inductive components - Electrical characteristics and measuring methods - Rated current of inductors for DC to DC converters