This part of GB/T 18290 is applicable to ID connections that are not accessible when tested and measured according to Part 3, and such connections are: - properly designed ID terminals; - have solid round conductors (nominal diameter 0.25 mm to 3.6 mm) wires; -- wires with stranded conductors (with a cross-section of 0.05 mm2~10 mm2). This connection is used in communication equipment and electronic equipment using similar technologies. In addition, in order to obtain a stable electrical connection under the specified environmental conditions, in addition to the test procedures, this part also specifies some empirical data based on actual industrial use.
GB/T 18290.4-2015 Referenced Document
GB/T 18290.3-2000 Solderless connections Part 3: Solderless accessible insulation displacement connections--General requirements,test methods and practical guidance
GB/T 2421.1-2008 Environmental testing for electric and electronic products.General and guidance
GB/T 4210-2001 Electrotechnical terminology Electromechanical components for electronic equipment
GB/T 5095.1-1997 Electromechanical components for electronic equipment. Basic testing procedures and measuring methods. Part 1: General
GB/T 5095.11-1997 Electromechanical components for electronic equipment. Basic testing procedures and measuring methods. Part 11: Climatic tests
GB/T 5095.2-1997 Electromechanical components for electronic equipment. Basic testing procedures and measuring methods. Part 2: General examination, electrical continuity and contact resistance tests, insulation tests and voltage stress tests
GB/T 5095.4-1997 Electromechanical components for electronic equipment. Basic testing procedures and measuring methods. Part 4: Dynamic stress tests
GB/T 5095.5-1997 Electromechanical components for electronic equipment. Basic testing procedures and measuring methods. Part 5: Impact tests (free components), static load tests (fixed components), endurance tests and overload tests
GB/T 5095.6-1997 Electromechanical components for electronic equipment. Basic testing procedures and measuring methods. Part 6: Climatic tests and soldering tests
IEC 60189-3:1988 Low-frequency cables and wires with P.V.C. insulation and P.V.C. sheath. Part 3: Equipment wires with solid or stranded conductor, PVC insulated, in singles, pairs and triples