13.220.99 有关消防的其他标准 标准查询与下载

PD CEN/TR 16793:2016 阻火器的选择 应用和使用指南

Guide for the selection@ application and use of flame arresters

LST EN 12101-3-2015 烟雾和热量控制系统. 第3部分: 动力烟雾和热量控制通风机(风扇)规格

Smoke and heat control systems - Part 3: Specification for powered smoke and heat control ventilators (Fans)

DIN EN 12101-3:2015 烟和热控制系统.第3部分:动力烟和排放热通风机的规范(风扇);德文版本EN 12101-3-2015

Smoke and heat control systems - Part 3: Specification for powered smoke and heat control ventilators (Fans); German version EN 12101-3:2015

ISO 13344:2015 火焰中致命毒性的评估

Estimation of the lethal toxic potency of fire effluents

GA/T 1276-2015 道路交通事故被困人员解救行动指南

本标准规定了道路交通事故被困人员解救行动的术语及定义、接警出动、侦察检测、区域控制、安全防护、车体稳固、险情排除、开辟救援通道、拓展救援空间、营救被困人员以及移交归队等内容。 本标准适用于公安消防部队组织实施的道路交通事故(不包括危险化学品泄漏情况)被困人员解救行动。政府专职消防队、志愿消防队等其他专业救援队伍进行道路交通事故被困人员解救行动可参照执行。

Action Guide for Rescue Persons Trapped in Road Traffic Accidents

GSO IEC/TS 60695-6-31:2015 火灾危险测试 第6-31部分：烟雾遮蔽 小规模静态测试 材料

This part of IEC 60695 describes the test methods for the determination of the specific optical density of smoke produced by materials used in electrotechnical products using the apparatus described in technical specification IEC/TS 60695-6-30. Test specimens are exposed vertically to a radiant heat source with or without the application of a pilot flame in a closed chamber (i.e. without air-change). The test methods are only applicable to flat, solid, non-metallic test specimens of materials used in electrotechnical products. This technical specification does not provide a classification system for the behaviour of materials. The test methods are not applicable to materials which melt and flow away from the direct impingement of heat flux. The test methods are not recommended for further development for electrotechnical products,nor are they recommended as the basis for regulation or other controls on smoke release due to the limitations of the physical fire model and the test specimen geometry – see Clause 4. WARNING: Appropriate safety measures are to be taken as toxic and harmful fire effluents may be produced by pyrolysis or combustion of test specimens. This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.

Fire hazard testing - Part 6-31: Smoke obscuration - Small-scale static test - Materials

DB22/T 223-2015 城镇消防水鹤建设

Urban Fire Crane Construction

DB22/T 2302-2015 电气火灾原因认定

Identifying the cause of an electrical fire

DB22/T 2301-2015 家庭旅馆消防要求

Family Hotel Fire Requirements

EN 12101-3:2015 烟和热控制系统.第3部分:电动排烟和排热通风装置规范

This European Standard specifies the products characteristics of powered smoke and heat control ventilators (fans) intended to be used as part of a powered smoke and heat control ventilation system in construction works. It provides test and assessment methods of the characteristics and the compliance criteria of the test assessment results. This European Standard applies to the following: a) fans for smoke and heat control ventilation; b) impulse/jet fans for smoke and heat control ventilation.

Smoke and heat control systems - Part 3: Specification for powered smoke and heat control ventilators (Fans)

KS F ISO TR 9122-4-2015 火灾废水毒性试验第4部分：火灾模型（小规模试验用的炉和燃烧装置）

Toxicity testing of fire effluents－Part 4：The fire model (furanaces and combustion apparatus used in small-scale testing)

KS F ISO TR 9122-3-2015 火灾废水毒性试验第3部分：火灾废水中气体和蒸气的分析方法

Toxicity testing of fire effluents－Part 3：Methods for the analysis of gases and vapours in fire effluents

KS F ISO TR 9122-2-2015 火灾废水毒性试验第2部分：火灾废水急性吸入毒性生物测定导则（基本原则、标准和方法）

Toxicity testing of fire effluents－Part 2：Guidelines for biological assays to determine the acute inhalation toxicity of fire effluents(basic principles, criteria and methodology)

KS F ISO TR 9122-1:2015 燃烧生成物毒性试验.第1部分:总则

Toxicity testing of fire effluents－Part 1：General

KS F ISO TR 9122-5:2015 燃烧生成物毒性试验.第5部分:预测燃烧生成物的毒性

Toxicity testing of fire effluents - Part 5 Prediction of toxic effects of fire effluents

KS F ISO TR 9122-2:2015 燃烧排出的毒性试验.第2部分:燃烧排出物中确定急性吸入毒性用生物检定指南(基本原理、准则和方法)

Toxicity testing of fire effluents-Part 2:Guidelines for biological assays to determine the acute inhalation toxicity of fire effluents(basic principles, criteria and methodology)

KS F ISO TR 9122-3:2015 燃烧废物的毒性试验.第3部分:燃烧废气和蒸气的分析方法

Toxicity testing of fire effluents-Part 3:Methods for the analysis of gases and vapours in fire effluents

KS F ISO TR 9122-4:2015 燃烧废物的毒性试验.第4部分:燃烧模式(小型试验中使用的燃烧炉和燃烧装置)

Toxicity testing of fire effluents－Part 4：The fire model (furanaces and combustion apparatus used in small-scale testing)

DB31/T 912-2015 浸入式电阻加热器着火物证技术鉴定方法

本标准规定了浸入式电阻加热器具火灾物证技术鉴定方法的原理、仪器设备、样品的提取与制备、分析步骤和判定依据。 本标准适用于在调查涉及浸入式电阻加热器具的火灾原因时，根据加热器具内部电阻丝表面的微观形貌及金属元素组成的特征，鉴别加热器具经历状态与火灾原因的关系。适用于电阻丝金属成分为铝（Al）、铬（Cr）和铁（Fe），填充物为石英砂的电阻加热器具，其他填充物可参照执行。

Technical determination method for fire material evidence of immersion resistance heaters

DIN EN 15882-2:2015 服务设施耐火试验结果的扩展应用 第2部分：防火阀；德文版 EN 15882-2:2015

Extended application of results from fire resistance tests for service installations - Part 2: Fire dampers; German version EN 15882-2:2015