81.060.10 原料 标准查询与下载
共找到 320 条与 原料 相关的标准，共 22 页
The document specifies a method for the determination of pH value of suspensions of non-soluble ceramic powders, e.g. silicon carbide, silicon nitride, alumosilicates.#,,#
Testing of ceramic raw materials and ceramic materials - Determination of pH value of suspensions of non-soluble powders
- ICS
- 81.060.10
- CCS
- Q30
- 发布
- 2003-02
- 实施
This document specifies a method for the determination of change of mass during drying at (135 ?5) ?and a method for preparation and storing of a final sample for the chemical analysis of ceramic raw materials and unshaped refractories as well as shaped refractories.
Testing of ceramic materials - Preparation of samples for the determination of change of mass during drying and for chemical analysis
- ICS
- 81.060.10
- CCS
- Q30
- 发布
- 2002-12
- 实施
This document specifies a method for the the determination of change in mass on ignition in air or inert gas atmosphere at a temperature of (1200 ?25) ? It is appliable for all oxidic raw materials and materials in the technical field of refractories and ceramics with exception of refractories containing silica and/or alumina.
Testing of oxidic raw materials and materials - Determination of change in mass on ignition
- ICS
- 81.060.10
- CCS
- Q30
- 发布
- 2002-12
- 实施
This standard specifies a method for the determination of the content of calcium oxide in alumosilicates of fine ceramics. Analogously, this standard is also applicable to oxidic raw materials and materials such as feldspar, kaolin, clays. The method is suitable for the determination of mass fractions of calcium oxide from 0,01 % to 20 %.
Testing of ceramic raw materials and materials - Chemical analysis of alumosilicates - Part 7: Determination of calcium oxide (CaO)
- ICS
- 81.060.10
- CCS
- Q30
- 发布
- 2002-12
- 实施
이 규격은 액상에 분산된 파인 세라믹스 원료 입자에 레이저광을 조사하여 검출된 산란 강도
Determination of particle size distributions for fine ceramic raw powders by laser diffraction method
- ICS
- 81.060.10
- CCS
- Q32
- 发布
- 2001-11-20
- 实施
- 2001-11-20
Determination of particle size distributions for fine ceramic raw powders by laser diffraction method
- ICS
- 81.060.10
- CCS
- 发布
- 2001-11-20
- 实施
Determination of particle size distributions for fine ceramic raw powders by laser diffraction method
- ICS
- 81.060.10
- CCS
- 发布
- 2001-11-20
- 实施
METHODS FOR CHEMICAL ANALYSIS OF FINE SILICON NITRIDE POWDERS FOR FINE CERAMICS
- ICS
- 81.060.10
- CCS
- 发布
- 20011011
- 实施
- 20011011
1.1 This test method covers the determination of particle size distribution of alumina or quartz using laser light scattering instrumentation in the range from 0.1 to 500 956;m.1.2 The procedure described in this test method may be applied to other nonplastic ceramic powders. It is at the discretion of the user to determine the method''s applicability.1.3 This test method applies to analysis using aqueous dispersions.1.4 This standard may involve hazardous materials, operations and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.1.4 Quartz has been classified by IARC as a Group I carcinogen. For specific hazard information in handling this material, see the supplier''s Material Safety Data Sheet.
Standard Test Method for Determining Particle Size Distribution of Alumina or Quartz by Laser Light Scattering
- ICS
- 81.060.10
- CCS
- Q30
- 发布
- 2001
- 实施
The document specifies two decomposition methods for the determination of silica in aluminosilicates of fine ceramics with mass fractions of silica from 20 % to 90 %, alumina less than or equal to 45 % andlow mass fractions of components less than or equal to 1 %, difficulty decomposable, such as corundum.#,,#
Testing of ceramic materials - Part 2: Chemical analysis of alumosilicates, determination of silicium(IV)-oxide
- ICS
- 81.060.10
- CCS
- Q30
- 发布
- 2000-06
- 实施
이 규격은 주로 액정용 소다석회 유리 기판의 내알카리성(알칼리 확산 방지 성능)을 개선하기
Testing methods for the adhesion of silica coating to the glass substrate
- ICS
- 81.060.10
- CCS
- Q30
- 发布
- 1999-07-12
- 实施
- 1999-07-12
Testing methods for the adhesion of silica coating to the glass substrate
- ICS
- 81.060.10
- CCS
- 发布
- 1999-07-12
- 实施
本标准规定．使精密陶瓷粉末粒子在均匀分散状态下沈降，而以光透过法测定粒径分布之方法。
Method of test for particle size distribution of fine ceramic podwer by liquid photosedimentation method
- ICS
- 81.060.10
- CCS
- 发布
- 1999-06-28
- 实施
- 1999-06-28
本标准规未经造粒之精密陶瓷原料粒径分布测定用共通湿式试样调制法。
General rules of the sample preparation for particle size analysis of fine ceramic raw powder
- ICS
- 81.060.10
- CCS
- 发布
- 1999-06-28
- 实施
- 1999-06-28
本标准规定．依比重瓶法，悬吊法及气体置换法，测定精密陶瓷粉末粒子密度之方法。备考：本标准中，｛ ｝ 内之单位系公制，数值为近似值。
Method of test for particle density of fine ceramic powder
- ICS
- 81.060.10
- CCS
- 发布
- 1999-06-28
- 实施
- 1999-06-28
本标准规定主要应用于机械、耐热及耐化学用途之致密质精密陶瓷，在 1300℃ 以下高温之维克氏硬度试验法。
Method of test for vickers hardness of fine ceramics at elevated temperatures
- ICS
- 81.060.10
- CCS
- 发布
- 1999-06-28
- 实施
- 1999-06-28
本标准规定在室温大气中实施之精密陶瓷三点弯曲，四点弯曲疲劳试验法。
Methods of test for bending fatigue of fine ceramics at room temperature
- ICS
- 81.060.10
- CCS
- 发布
- 1999-06-28
- 实施
- 1999-06-28
METHODS FOR CHEMICAL ANALYSIS OF FINE SILICON NITRIDE POWDERS FOR FINE CERAMICS
- ICS
- 81.060.10
- CCS
- 发布
- 1998-12-17
- 实施
