81.060.10 原料 标准查询与下载

KS L 4003-2007(2022) 陶瓷陶瓷粘土的湿筛分析试验方法

Testing method for wet sieve analysis of ceramic whiteware clays

KS L 4002-2007(2022) 陶瓷白粘土中游离水分的试验方法

Testing method for free moisture in ceramic whiteware clays

KS L 4003-2007(2017) 测试方法陶瓷粘土湿筛析

Testing method for wet sieve analysis of ceramic whiteware clays

KS L 4003-2007 陶瓷用黏土湿式筛析试验方法

이 규격은 도자기용 점토(이하 점토라 한다.)의 습식 체가름 시험 방법에 대하여 규정한다.

Testing method for wet sieve analysis of ceramic whiteware clays

KS L 4002-2007 陶瓷用黏土中游离水分的测定

이 규격은 도자기용 점토의 유리 수분 측정 방법에 대하여 규정한다.

Testing method for free moisture in ceramic whiteware clays

JIS R 1603:2007 精细陶瓷用氮化硅细粉末的化学分析方法

この規格は，フアインセラミックス製造の原料として用いられる窒化けい素微粉末の化学分祈方法について規定する。

Methods for chemical analysis of fine silicon nitride powders for fine ceramics

DS/EN 725-3:2007 先进技术陶瓷 陶瓷粉末的试验方法 第3部分：通过载气热萃取法测定非氧化物的氧含量

This part of EN 725 describes a method for the determination of the oxygen content of non-oxide powders used for advanced technical ceramics, using an inert carrier gas thermal extraction method. The method described is suitable for oxygen contents of less than 3 %.NOTE An indication of the limits of determination is usually given by the manufacturers of the gas analysis apparatus used. However, for a specific measurement procedure, such limits can be determined by experiments conducted by the user.

Advanced technical ceramics - Methods of test for ceramic powders - Part 3: Determination of the oxygen content of non-oxides by thermal extraction with a carrier gas

DS/EN 725-5:2007 高级技术陶瓷 陶瓷粉末的试验方法 第5部分：粒度分布的测定

This Part of EN 725 describes the preparation of suspensions and calibration of apparatus, prior to the measurement of particle size distribution of powders used for advanced technical ceramics.The preparation described is appropriate for measurements either by the sedimentation method or the laser light scattering method.

Advanced technical ceramics - Methods of test for ceramic powders - Part 5: Determination of particle size distribution

JC/T 1044-2007 金属波纹联接水管

本标准规定了金属波纹联接水管（简称波纹管）的产品分类与标记、技术要求、试验方法、检验规则和标志、包装、运输和贮存。 本标准适用于给水管路上，公称（工作）压力≤1.0MPa的波纹管。

Flexible water connectors

JC/T 1047-2007 陶瓷色料用电熔氧化锆

本标准规定了陶瓷色料用电熔氧化锆的要求、试验方法、检验规则以及标志、包装、运输和储存。 本标准适用于电熔法生产的工业氧化锆，该产品主要用于陶瓷色料行业。 分子式ZrO 相对分子质量：123.22（按2001国际相对原子量）

Fused zirconia used for ceramics pigment

JC/T 1046.2-2007 建筑卫生陶瓷用色釉料 第2部分:建筑卫生陶瓷用色料

本标准规定了建筑卫生陶瓷坯、釉用色料术语、产品分类、要求、试验方法、检验规则、标志、包装、运输和贮存。 本标准适用于建筑卫生陶瓷用色料。

Glazes and stains for building and sanitary ceramics Part 2: Stains for building and sanitary ceramics

JC/T 1046.1-2007 建筑卫生陶瓷用色釉料 第1部分:建筑卫生陶瓷用釉料

本标准规定了建筑陶瓷卫生陶瓷用釉料的术语、产品分类、要求、试验方法、检验规则、标志、包装、运输和贮存。 本标准适用于建筑卫生陶瓷用釉料与熔块。

Glazes and stains for building and sanitary ceramics Part 1: Glazes for building and sanitary ceramics

KS L 3412-2007 石墨中灰分含量测定方法

이 규격은 흑연 중의 회분 함량 측정 방법에 대하여 규정한다. 이 시험 방법에 의해 측정된

Testing method for ash in graphite

KS L 3413-2007 石墨中水分含量测定方法

이 규격은 흑연 속에 함유되어 있는 수분의 함량을 측정하는 방법에 대하여 규정한다.여기

Testing method for moisture in graphite

KS L 3413-2007(2022) 石墨中水分的试验方法

Testing method for moisture in graphite

KS L 3413-2007(2017) 测试方法水分石墨

Testing method for moisture in graphite

KS L 5506-2006 未烧结黏土抗折强度试验方法

이 규격은 건조된 상태 또는 상대 습도 50 % 또는 80 %에서 조정한 도자기용 점토 성

Testing method for modulus of rupture of unfired clays

KS L 5506-2006(2016) 测试方法模量破裂未烧制粘土的

Testing method for modulus of rupture of unfired clays

KS L 5506-2006(2021) 未燃烧粘土断裂模量的试验方法

Testing method for modulus of rupture of unfired clays

DIN 51085:2006 氧化原料和基本材料试验.总硫含量测定

This standard specifies two methods for the determination of total sulfur content in oxidic raw and basic materials, the gravimetric method for mass fractions of sulphur greater than or equal to 0,10 % and the IR-detection after combustion for mass fractions of sulphur greater than or equal to 0,005 %.#,,#

Testing of oxidic raw and basic materials - Determination of total sulphur content