K47 输电线路器材 标准查询与下载

DL/T 319-2010 架空输电线路施工抱杆通用技术条件及试验方法

本标准规定了架空输电线路施工用抱杆的分类、技术要求、试验方法、检验规则、包装、标志、运输与储存等，作为设计、制造和验收的依据。 本标准适用于架空输电线路施工中整体组立或分体组立杆塔所用的金属抱杆，其他材料及用途的抱杆可参照执行。

General technical requirements and test methods for holding poles of overhead transmission line construction

DL/T 683-2010 电力金具产品型号命名方法

本标准规定了电力金具产品型号命名的方法。 本标准适用于额定电压在35kV及以上架空电力线路、变电站及电厂配电装置用的金具。

Nomenclature for fitting model

DL/T 346-2010 设备线夹

本标准规定了设备线夹的型式、分类、技术要求、试验方法、验收规则、标志与包装及型号命名方法。 本标准适用于发电厂和变电站配电装置中母线引下线与电气设备及电气设备间连接的设备线夹。

Terminal connector

DL/T 347-2010 T型线夹

本标准规定了T型线夹的型式、分类、技术要求、试验方法、验收规则、标志与包装及型号命名方法。 本标准适用于架空电力线路、电厂及变电站配电装置中母线与引下线T接的T型线夹。

T-connector

DIN EN 50341-3-4:2011 交流电压超过45 kV的架空电线.第3部分:国家标准(NNA);德文版本EN 50341-3-4-2001 + Cor.1-2006 + Cor 2:2010

Overhead electrical lines exceeding AC 45 kV - Part 3: National Normative Aspects (NNA); German version EN 50341-3-4:2001 + Cor. 1:2006 + Cor. 2:2010

ANSI C119.1-2011 额定电压为600伏的密封绝缘式地下连接器系统

This standard covers sealed, insulated underground connector systems rated at 600 volts for utility applications and establishes electrical, mechanical, and sealing requirements for sealed underground connector systems. The purpose of this standard is to give reasonable assurance to the user that sealed insulated underground connector systems meeting the requirements of this standard will perform in a satisfactory manner, provided they have been properly selected for the intended application and are installed in accordance with the manufacturer's recommendation.

Sealed Insulated Underground Connector Systems Rated 600 Volts

ANSI/IEEE 1808:2011 采集和管理输电线检查和维修数据用指南

This guide provides reference information to assist electric utilities and their contractors with the development of computer-based means for collecting and managing transmission line inspection and maintenance data and associated asset information including transmission line inventory data. It provides a high level overview of key principles and considerations learned through experience that will help ensure common pitfalls are avoided and enhance the usability of systems.

Guide for Collecting and Managing Transmission Line Inspection and Maintenance Data

BS EN 50528:2010 低压电气装置或附近区域用绝缘梯

Insulating ladders for use on or near low voltage electrical installations

DIN EN 60832-1:2010 带电作业.绝缘杆及附件设备.第1部分:绝缘杆(IEC 60832-1-2010);德文版本EN 60832-1-2010 + Cor. -2010

Live working - Insulating sticks and attachable devices - Part 1: Insulating sticks (IEC 60832-1:2010); German version EN 60832-1:2010 + Cor. :2010

IEEE 1410/INT 1-2-2010 电力架空配电线的雷电防护性能改进指南

Guide for Improving the Lightning Performance of Electric Power Overhead Distribution Lines

IEEE Std C57.12.31-2010 柱上设备用IEEE标准.附件集成

IMPORTANT NOTICE: This standard is not intended to ensure safety, security, health, or environmental protection. Implementers of the standard are responsible for determining appropriate safety, security, environmental, and health practices or regulatory requirements. This IEEE document is made available for use subject to important notices and legal disclaimers. These notices and disclaimers appear in all publications containing this document and may be found under the heading “Important Notice” or “Important Notices and Disclaimers Concerning IEEE Documents.” They can also be obtained on request from IEEE or viewed at http://standards.ieee.org/IPR/disclaimers.html. This standard covers conformance tests and requirements for the enclosure integrity of pole-mounted equipment containing apparatus energized in excess of 600 V, typically not accessible to the general public, such as but not limited to the following types of equipment: a) Pole-mounted distribution transformers b) Pole-mounted switches c) Pole-mounted regulators d) Pole-mounted metering equipment e) Pole-mounted reclosers/sectionalizers f) Pole-mounted capacitors

IEEE Standard for Pole-Mounted Equipment.Enclosure Integrity

BS EN 62192:2009 带电作业–绝缘绳索

This International Standard covers insulating ropes that are utilized during live working procedures in contact with parts of installations operating at voltages up to and including 800 kV r.m.s. Insulating ropes for live working procedure under rain and/or d.c. conditions are not covered by this standard.

Live working - Insulating ropes

BS EN 50540:2010 架空线导体.钢支持铝导线（ACSS）

This European Standard specifies the electrical and mechanical characteristics of ACSS conductors made of round or formed annealed aluminium wires and steel wires stranded in alternate directions, made of one or a combination of any of the following.

Conductors for overhead lines - Aluminium conductors steel supported (ACSS)

DL/T 371-2010 架空输电线路放线滑车

本标准规定了架空输电线路放线滑车的型式、主要技术参数、技术要求、检验方法、检验规定等。 本标准适用于架空输电线路架线施工使用的常规放线滑车的设计、制造、检验。 本标准涉及的放线滑车主要用来展放导线、架空地线和光纤复合架空地线等。其他功用(大跨越用放线滑车、转向用放线滑车等)、非常规展放方式(直升机放线、不平衡放线等)下使用的特殊放线滑车可参照本标准。

Stringing blocks of overhead transmission lines

DL/T 372-2010 输电线路张力架线用牵引机通用技术条件

本标准规定了牵引机的产品型式、主要技术参数、技术要求、试验方法、检验规则内容等，作为设计、制造、试验及验收的技术依据。 本标准适用于架空输电线路用于牵引展放导线、地线、光缆等的牵引机。

General technical specification for pullers pulling conductors under controlled tension of overhead transmission line

DL/T 357-2010 输电线路行波故障测距装置技术条件

本标准规定了输电线路行波故障测距装置的基本技术要求、试验方法、检验规则及对标志、包装、运输、贮存的要求。 本标准适用于基于行波原理的交流、直流输电线路故障测距装置(以下简称行波故障测距装置)的设计、制造、检验和使用。

Specification for transmission line fault location equipment based on traveling wave

NF C68-123*NF EN 50085-2-3:2010 电器装置用电缆干线装置和管道设备.第2-3部分:小室内设备用有槽电缆干线装置的详细要求

Cable trunking systems and cable ducting systems for electrical installations - Part 2-3 : particular requirements for slotted cable trunking systems intended for installation in cabinets.

BS EN 50397-3:2010 交流额定电压大于1 kV和不超过36 kV的高架电力线和相关配件用包覆导线.使用指南

This part of EN 50397 provides general recommendations for the selection, storage, transportation and installation of the covered conductors and the related accessories specified in Parts 1 and 2 of the standard, unless otherwise specified. Safety regulations and environmental regulations as well as rules for installation and mechanical design are not considered in this Guide to use, as they are covered by relevant national regulations and laws. Relevant national regulations are not considered in this guide, but shall always be consulted as appropriate. It is assumed that the design of installations, the purchase and installation of covered conductors and of the related accessories specified in this EN is entrusted to suitably skilled and competent people. In case of doubt as to the suitability of covered conductors and the related accessories for a particular use, further specific information shall be obtained from the manufacturer.

Covered conductors for overhead lines and the related accessories for rated voltages above 1 kV a.c. and not exceeding 36 kV a.c. Guide to use

DIN EN 61112:2010 带电作业. 电绝缘毯（IEC 61112: 2009）; 德文版本EN 61112: 2009

This standard is applicable to electrical insulating blankets for the protection of workers from accidental contact with live or earthed electrical conductors, apparatus or circuits and avoidance of short circuits on electrical installations. Electrical insulating blankets in rolls having a width lower than 50 mm are not covered by this standard.

Live working - Electrical insulating blankets (IEC 61112:2009); German version EN 61112:2009

IEC 60832-1:2010 带电作业.绝缘杆及附件设备.第1部分:绝缘杆

This part of IEC 60832 gives the essential requirements for insulating sticks for live working for use on a.c. electrical installations. Part 2 of IEC 60832 covers devices that can be attached onto and removed from the fitting of the insulating sticks. The products designed and manufactured according to this standard contribute to the safety of the users provided they are used by skilled persons@ in accordance with safe methods of work and the instructions for use.

Live working - Insulating sticks and attachable devices - Part 1: Insulating sticks