GB 3883.1-2000
Safety of hand-held motor-operated electric tools-Part 1:General requirements

Be replaced

Standard No.

GB 3883.1-2000

Language

Chinese

Release Date

2000

Published By

General Administration of Quality Supervision, Inspection and Quarantine of the People‘s Republic of China

Replace By

GB 3883.1-2005

GB 3883.11-2005

Lastest

GB 3883.1-2014

GB/T 3883.1-2014

GB/T 3883.21-2012

GB 3883.21-2012

GB 3883.11-2012

Scope

This standard deals with the safety of hand-held electric tools with AC single-phase and DC rated voltages not greater than 250V and AC three-phase rated voltages not greater than 440V driven by motors or electromagnets. These tools can be equipped with electric heating elements. This standard deals as far as possible with the common hazards caused by hand-held tools that people actually encounter in their daily use of tools. Note: Hand-held power tools (hereinafter referred to as tools) that can be mounted on a support and can be used as stationary tools without changing the tool itself are also included in the scope of this standard; however, in this case, additional requirements may be required, As specified in Part II. Pay attention to the following facts: ---- Hand-held tools used in vehicles, boats or aircraft may require additional requirements; ---- Hand-held tools used in tropical countries may require special requirements; ---- In many countries, There are additional requirements stipulated by the competent departments of health, labor protection, and water sources. This standard does not apply to: ----Hand-held tools used in places where there are often special conditions such as corrosive or explosive atmospheres (dust, steam or gas); ----Hand-held tools for medical use (IEC 601) . Electric heating tools belong to IEC 335-2-45. For motors that are not isolated from the mains and whose basic insulation is not designed for the rated voltage of the tool, the requirements are specified in Annex B.

GB 3883.1-2000 history

• 2014 GB 3883.1-2014 Safety of motor-operated hand-held, transportable electric tools and lawn and garden tools.Part 1:General requirements
• 2012 GB 3883.11-2012 Safety of hand-held motor-operated electric tools.Part 2:Particular requirements for reciprocating saws(jig and sabre saws)
• 2008 GB 3883.1-2008 Safety of hand-held motor-operated electric tools.Part 1:General requirements
• 2005 GB 3883.11-2005 Safety of hand-held motor-operated electric tools-Part 2:Particular requirements for reciprocating saws(Jig and Sabre Saws)
• 2000 GB 3883.1-2000 Safety of hand-held motor-operated electric tools-Part 1:General requirements
• 1991 GB 3883.11-1991 Safety of hand-held motor-operated electric tools--Part 11: Particular requirements for electric reciprocating saws (jig and sabre saws)

GB 3883.1-2000 -All Parts