C81 火警监视、报警与消防调度系统 标准查询与下载

DIN VDE 0833-3:2009 火灾,入侵和拦劫报警系统.第3部分:入侵和拦截报警系统的要求

Alarm systems for fire, intrusion and hold-up - Part 3: Requirements for intrusion and hold-up alarm systems

DIN 14623:2009 自动火警探测器的定位标志

Signs for orientation at automatic fire detectors

UL 268-2009 火警系统烟雾探测器

Smoke detectors for fire alarm systems

ISO 7240-17:2009 失火探测和失火报警系统.第17部分:短路光电隔离器

Fire detection and fire alarm systems - Part 17: Short-circuit isolators

DIN EN 50194-1:2009 家用易燃气体监测用电气设备.第1部分:试验方法和性能要求.德文版本EN 50194-1-2009

Electrical apparatus for the detection of combustible gases in domestic premises - Part 1: Test methods and performance requirements; German version EN 50194-1:2009

IEC 60079-29-1:2007/ISH1:2009 爆炸性环境.第29-1部分:气体探测器.易燃气体探测器的性能要求.说明表单1

Explosive atmospheres - Part 29-1: Gas detectors - Performance requirements of detectors for flammable gases; Interpretation sheet 1

SANS 50054-1:2009 火灾探测及火警系统.第1部分:引言

Specifies requirements, test methods and performance criteria against which the effectiveness and reliability of the component parts of fire detection and fire alarm systems can be assessed. Specifies requirements and test methods against which the abili

Fire detection and fire alarm systems Part 1: Introduction

DIN 14675/A2:2009 火灾探测和火灾报警系统.设计和操作.修改件A2

Fire detection and fire alarm systems - Design and operation; Amendment A2

DIN VDE 0833-2:2009 火灾,侵入和拦截报警系统.第2部分:火警系统的要求

Alarm systems for fire, intrusion and hold up - Part 2: Requirements for fire alarm systems

ISO 7240-11:2005/Amd 1:2009 火灾探测和报警系统.第11部分:手摇呼叫点.修改件1

Fire detection and alarm systems - Part 11: Manual call points; Amendment 1

NF S61-970/A1:2009 火灾探测系统用安装规则

Installation rules for fire detection systems.

ISO 7240-27:2009 火灾探测和报警系统.第27部分:用分散光、传送光或电离烟雾传感器、电气化学电池一氧化碳传感器和热传感器的点型火灾探测器

This part of ISO 7240 specifies requirements, test methods and performance criteria for multi-sensor point-type fire detectors that incorporate an optical or ionization smoke sensor, an electro-chemical cell for sensing carbon monoxide (CO) and, optionally, one or more heat sensors, for use in fire detection and alarm systems installed in buildings (see ISO 7240-1). For the testing of other types of fire detectors using smoke, CO and, optionally, heat sensors working on different principles, this part of ISO 7240 can be used only for guidance. Fire detectors using smoke, CO and, optionally, heat sensors which have special characteristics and which have been developed for specific risks are not covered by this part of ISO 7240.

Fire detection and alarm systems - Part 27: Point-type fire detectors using a scattered-light, transmitted-light or ionization smoke sensor, an electrochemical-cell carbon-monoxide sensor and a heat sensor

SANS 728-8:2009 自动火灾探测及报警系统.第8部分:多点送气烟雾探测器

Specifies requirements for the design, construction and performance of aspirated system type smoke detectors used in automatic fire detection and alarm systems. Covers multi-point aspirated systems and their associated detector and control facilities. Do

Automatic fire detection and alarm systems Part 8: Multi-point aspirated smoke detectors

DIN EN 14604:2009 烟雾报警装置

This document specifies requirements, test methods, performance criteria, and manufacturer's instructions for smoke alarms that operate using scattered light, transmitted light or ionization, intended for household or similar residential application. This document includes additional requirements for smoke alarms, which are also suitable for use in leisure accommodation vehicles. For the testing of other types of smoke alarms, or smoke alarms working on different principles, this document should only be used for guidance. Smoke alarms with special features, such as radio interlinking or special characteristics and developed for specific risks, are not covered by this document. This document allows, although it does not require, the inclusion within the smoke alarm of facilities for interconnection with other similar smoke alarms and/or accessories, and for alarm silencing. Where such facilities are included, this document specifies applicable requirements. This document does not cover devices intended for incorporation in systems using separate control and indicating equipment. NOTE Certain types of smoke alarms contain radioactive materials. The national requirements for radiation protection differ from country to country and they are not specified in this document. Such smoke alarms should, however, comply with the applicable national requirements.

Smoke alarm devices; English version of DIN EN 14604:2009-02

DIN EN 54-25:2009 火灾探测和火灾报警系统.第25部分:使用无线电链路的部件

This European Standard specifies requirements, test methods and performance criteria for components used in fire alarms systems, installed in and around buildings, which use radio frequency links (RF links) to communicate. It also provides requirements for the evaluation of conformity of the components to the requirements of this European Standard. Where components work together and this requires knowledge of the system design, this document also specifies requirements on the system. When the fire detection and fire alarm systems (FDAS) use wired and RF links, the relevant parts of EN 54 apply together with this document. Requirements relevant to wire links are superseded or modified by those included in this European Standard. This document does not restrict: -- the intended use of radio spectrum, e.g. frequency, power output of devices; -- the allowed maximum number of the components using RF links within the FDAS or one transmission path and/or RF link; -- the allowed maximum number of the components affected by loss of one transmission path and/or RF link. These requirements relate to national regulations and can vary from member state to member state.

Fire detection and fire alarm systems - Part 25: Components using radio links; German version EN 54-25:2008

DIN EN 54-20:2009 火灾探测和火灾报警系统 第20部分:除烟尘探测器

This European Standard specifies the requirements, test methods and performance criteria for aspirating smoke detectors for use in fire detection and fire alarm systems installed in buildings. Aspirating smoke detectors developed for the protection of specific risks that incorporate special characteristics (including additional features or enhanced functionality for which this standard does not define a test or assessment method) are also covered by this standard. The performance requirements for any special characteristics are beyond the scope of this standard. NOTE Certain types of detector contain radioactive materials. The national requirements for radiation protection differ from country to country and they are not therefore specified in this standard.

Fire detection and fire alarm systems - Part 20: Aspirating smoke detectors (includes Amendment AC:2008); English version of DIN EN 54-20:2009-02

ANSI/ISA 18.2-2009 加工工业报警系统的管理

1.1 General Applicability This standard addresses alarm systems for facilities in the process industries to improve safety, quality, and productivity. The general principles and processes in this standard are intended for use in the lifecycle management of an alarm system based on programmable electronic controller and computer based Human-Machine Interface (HMI) technology. Implementation of this standard should consider alarms from all systems presented to the operator, which may include basic process control systems, annunciator panels, safety instrumented systems, fire and gas systems, and emergency response systems.

Management of Alarm Systems for the Process Industries

ANSI/UL 268-2009 火灾报警信号系统烟雾探测器

Proposed Sixth Edition of UL 268, Smoke Detectors for Fire Alarm Systems, as a Binational Standard.

Smoke Detectors for Fire Alarm Signaling Systems

ANSI/UL 268A-2009 烟道用烟雾探测器

Formalize requirements to insure consistent application for products submitted beyond the temperature range of 0 - 38 degrees C.

Smoke Detectors for Duct Application

NF S61-932:2008 防火安全系统(FSS).防火系统用安装要求

Fire Safety Systems (FSS) - Installation rules for the fire protection system.