C81 火警监视、报警与消防调度系统 标准查询与下载

UL 38 BULLETIN-2008 UL安全标准.消防警报系统用人工信号报警箱.评议提交截止日期:2008年2月4日

Manual signaling boxes for fire alarm systems intended for permanent installation and used in ordinary locations

UL Standard for Safety Manual Signaling Boxes for Fire Alarm Systems COMMENTS DUE: FEBRUARY 4, 2008

ANSI/UL 268A-2008 烟道用烟雾探测器

Revision to proposal dated September 12, 2008

UL Standard for Safety Smoke Detectors for Duct Application (Fourth Edition; Reprint with Revisions Through and Including October 2@ 2014)

ANSI/UL 268Aa-2008 导管烟雾探测器

Revision to proposal dated September 12, 2008

Smoke Detectors for Duct Application

BS ISO 7240-8:2007 火灾探测和报警系统.使用带热传感器的电化电池的一氧化碳火灾探测器

This part of ISO 7240 specifies requirements, test methods and performance criteria for point multi-sensor fire detectors that incorporate an electrochemical cell for sensing carbon monoxide (CO) in combination with one or more heat sensors, for use in fire detection and alarm systems installed in buildings (see ISO 7240-1). For the testing of other types of CO multi-sensor fire detectors, or CO and heat multi-sensor fire detectors working on different principles, this part of ISO 7240 can be used for guidance. CO and heat multi-sensor fire detectors with special characteristics and developed for specific risks are not covered by this part of ISO 7240.

Fire detection and alarm systems. Carbon monoxide fire detectors using an electro-chemical cell in combination with a heat sensor

KS B ISO 14520-15:2007 气体灭火系统.物理特性和系统设计.第15部分:IG-541灭火剂

이 규격은 IG-541 소화약제와 관련된 물리적 성질, 사양, 사용과 안전을 포함하며 15

Gaseous fire-extinguishing systems－Physical properties and system design－Part 15：IG-541 extinguishant

KS B ISO 7240-5:2007 火灾探测和报警系统.第5部分:点式热探测器

이 규격은 건물의 화재감지 및 경보 시스템에서 스포트형 열감지기의 사용을 위한 필요조건,

Fire detection and alarm systems－Part 5：Point-type heat detectors

KS B ISO 7240-7:2007 火灾探测和报警系统.第7部分:使用散射光、透射光或电离作用的尖形烟雾探测器

이 규격은 건물에 설치되어 화재감지 및 화재경보 설비에 사용되는 광전식(산란광, 전달광)

Fire detection and alarm systems－Part 7：Point-type smoke detectors using scattered light, transmitted light or ionization

ANSI/UL 1730-2007 多户住宅区居住单元和饭店/宾馆房间中的感烟探测器、监视器及附件安全标准

These requirements cover electrically operated smoke detector monitors used in ordinary indoor locations per the National Electrical Code, NFPA 70; the Life Safety Code, NFPA 101; and Ch. 2 of the National Fire Alarm Code, NFPA 72. The monitor provides for the connection and supervision of initiating circuits that are connected to smoke detectors. It provides alarm or trouble indications at an attended monitoring location to supplement the signal indication at the location of the smoke detector.

Standard for Safety for Smoke Detector Monitors and Accessories for Individual Living Units of Multifamily Residences and Hotel/Motel Rooms

BS 5979:2007 遥控中心从火灾和安全系统接收信号.实施规程

This British Standard gives recommendations for the planning, construction and facilities of manned and unmanned remote centres, and for the operation of alarm receiving centres (ARCs) receiving signals from security systems, e.g. intruder, fire, social and closed circuit television (CCTV). Annex A provides guidance for inspectorates, Annex B contains guidance on remote access to remote centre data systems, Annex C gives a recommended agreement for authorizing filtering.

Remote centres receiving signals from fire and security systems – Code of practice

ISO 7240-8:2007 火灾探测和报警系统.第8部分:使用带热传感器的电化电池的一氧化碳火灾探测器

This part of ISO 7240 specifies requirements, test methods and performance criteria for point multi-sensor fire detectors that incorporate an electrochemical cell for sensing carbon monoxide (CO) in combination with one or more heat sensors, for use in fire detection and alarm systems installed in buildings (see ISO 7240-1). For the testing of other types of CO multi-sensor fire detectors, or CO and heat multi-sensor fire detectors working on different principles, this part of ISO 7240 can be used for guidance. CO and heat multi-sensor fire detectors with special characteristics and developed for specific risks are not covered by this part of ISO 7240.

Fire detection and alarm systems - Part 8: Carbon monoxide fire detectors using an electro-chemical cell in combination with a heat sensor

ISO 7240-19:2007 火灾探测和报警系统.第19部分:应急用发声系统设计、安装、交付使用和服务

This part of ISO 7240 specifies the design, installation, commissioning and service requirements for a sound system for emergency purposes (s.s.e.p.; see ISO 7240-1:2005, Figure 1, item C), which is primarily intended to broadcast information for the protection of lives within one or more specified indoor or outdoor areas during an emergency. The s.s.e.p. is intended to initiate a rapid and orderly mobilization of occupants in an emergency by including systems using loudspeakers to broadcast voice announcements for emergency purposes, alert signals complying with ISO 7731 (where applicable) and evacuation signals complying with ISO 8201. In some cases, sound systems are used in preference to sounders or bells in order to broadcast a range of coded warnings that is difficult to communicate with sounders or bells. The use of the s.s.e.p. for normal sound reinforcement and distribution systems purposes under non-hazardous circumstances is not excluded. When used for non-emergency purposes, the zoning of the loudspeakers can differ from the zones used for emergency purposes. This part of ISO 7240 does not apply to sound systems that use bells or sounders.

Fire detection and alarm systems - Part 19: Design, installation, commissioning and service of sound systems for emergency purposes

UL 268A BULLETIN-2007 UL安全标准.烟道用感烟探测器

These requirements cover air duct smoke detectors intended for indoor use within or protruding into a duct, or mounted in a housing with sampling tubes extending into or traversing a duct. Air duct smoke detectors are intended to be installed in ducts where the maximum air temperature inside the duct does not exceed 100?F (38?C), nor does the minimum temperature become less than 32?F (0?C).

UL Standard for Safety Smoke Detectors for Duct Application

UL 268 BULLETIN-2007 火警信号系统用烟雾探测器的UL安全标准

The following topics were discussed at the meeting: 1. Smoke Characterization Study 2. UL 217 Proposals – a) Use of Voice Message in Alarm Signal; b) Revised Descriptions of Smoke Box Air Circulation Fans; c) Additional Details of Jarring Test; and d) Packaging Marking Regarding Nuisance Alarms; e) Updated NFPA 72/11 Text References in Installation Instructions; f) Instructions on Nuisance Alarms; g) Revised Information Regarding Situations Where Smoke Alarms May Not Be Effective; h) Information Regarding Relative Performance of Ionization and Photoelectric Smoke Detectors, and i) Removal of Inaccurate Information in Section 65.2.1 3. UL 268 Proposals – a) Requirements Covering Aerosol Test Spray; b) Revised Descriptions of Smoke Box Air Circulation Fans; c) Removal of Inaccurate Information in Section 66.2; and d) Additional Installation Instruction Requirements for Projected Beam Type Smoke Detectors 4. Additional UL 217 Discussion Items 5. Update on Harmonization of ANSI/UL 268 & SCC/ULC-S529 6. Task Group Reports 7. Additional Agenda Item, UL 217 Proposal Requests – a) Silencing for Recreational RV’s and Boats; b) Battery Operating Temperature Range - RV Smoke Alarms; c) Battery Operating Temperature Range - Marine Smoke Alarms 8. Additional Agenda Item, UL 268 Proposal Request – Extended Temperature Range Testing

UL Standard for Safety Smoke Detectors for Fire Alarm Signaling Systems

NF S61-970:2007 火灾探测系统用安装规则

Installation rules for fire detection systems.

ISO 7240-16:2007 火灾探测和报警系统.第16部分:声音系统控制和指示设备

This part of ISO 7240 specifies the requirements, test methods and performance criteria for sound system control and indicating equipment (s.s.c.i.e.) for use in buildings and structures as part of a sound system for emergency purposes (s.s.e.p.) (item C of Figure 2 in ISO 7240-1:2005). The s.s.c.i.e. is primarily intended to broadcast information for the protection of lives within one or more specified areas in an emergency, to effect a rapid and orderly mobilization of occupants in an indoor or outdoor area. This includes systems using loudspeakers to broadcast voice announcements for emergency purposes, alert signals complying with ISO 7731, and evacuate signals complying with ISO 8201. The overall requirements of an s.s.e.p., especially concerning audibility and intelligibility, are contained within ISO 7240-19. In addition to ensuring compliance with this part of ISO 7240, the manufacturer should also consider the requirements of ISO 7240-19, national regulations, codes and standards that affect the s.s.c.i.e. design and usability. For example, some regulations require certain optional functions to be available on all s.s.c.i.e. installed within the jurisdiction. The use of the equipment for normal sound reinforcement and distribution systems purposes under nonhazardous circumstances is not excluded. This part of ISO 7240 can also be used for the assessment of similar control and indicating equipment for use in systems where the warning-signal broadcast does not include a voice message. This part of ISO 7240 does not apply to systems using only sounders or bells.

Fire detection and alarm systems - Part 16: Sound system control and indicating equipment

DIN EN 54-18 Berichtigung 1:2007 火灾探测和火灾报警系统.第18部分:输入/输出装置.DIN EN 54-18-2006技术勘误

Fire detection and fire alarm systems - Part 18: Input/output devices; German version EN 54-18:2005, Corrigenda to DIN EN 54-18:2006-03; German version EN 54-18:2005/AC:2007

DIN EN 54-18 Corrigendum 1:2007 火灾探测和火灾报警系统.第18部分:输入/输出装置.DIN EN 54-18-2006-03英文版的技术勘误1

Fire detection and fire alarm systems-Part 18:Input/output devices Corrigendum 1 to English version of DIN EN 54-18:2006-03

ISO 7240-10:2007 火灾探测和警报系统.第10部分:点型火焰探测器

This part of ISO 7240 specifies requirements,test methods and performance criteria for point-type,resettable flame detectors that operate using radiation from a flame for use in fire detection systems installed in buildings.Additional requirements for flame detectors for use in marine applications are specified in Annex A. This part of ISO 7240 does not cover flame detectors working on different principles from those desctibed in this document(althouth this part of ISO 7240 can be used as guidance in guidance in assessing such products).

Fire detection and alarm systems - Part 10: Point-type flame detectors

DIN EN 50194-2:2007 家用易燃气体监测用电气设备.第2部分:娱乐车辆和类似交通工具中固定安装的连续操作电气设备.附加试验方法和性能要求

Electrical apparatus for the detection of combustible gases in domestic premises - Part 2: Electrical apparatus for continuous operation in a fixed installation in recreational vehicles and similar premises - Additional test methods and performance requir

DIN EN 54-2/A1:2007 火灾探测和报警系统.第2部分:控制和指示设备

This amendment has been prepared CEN/TC 72 "Fire detection and fire alarm systems" (Secretariat: United Kingdom). The responsible German body involved in its preparation was the Normenausschuss Feuerwehrwesen (Fire Fighting Standards Committee), Technical Committee NA 031-02-01 AA Brandmelde- und Feueralarm- anlagen. The system requirements and technical application rules for control and indicating equipment complying with this standard and for their use in fire detection installations in buildings are specified in national Standards DIN 14675 and DIN VDE 0833-2 (VDE 0833-2) (see National Annex NA). This document includes Amendment A1:2006-10 to EN 54-2:1997. A consolidated version of EN 54-2 is currently being prepared by CEN/TC 72.

Fire detection and fire alarm systems - Part 2: Control and indicating equipment; English version of DIN EN 54-2/A1:2007-01