Q10 建材产品综合 标准查询与下载

DB37/T 5049-2015 预拌混凝土绿色生产及管理技术规程

本规程适用于山东省行政区域内预拌混凝土生产企业的建设和绿色生产管理及评价。

Technical regulations for green production and management of ready-mixed concrete

DB37/T 5046-2015 里氏硬度法现场检测建筑钢材抗拉强度技术规程

本规程适用于采用里氏硬度法检测并推定工业与民用建筑中钢结构用型钢（H 型钢、工字钢、钢板、钢管）及钢筋混凝土内钢筋的抗拉强度，型钢包括 Q235、Q345、Q390、Q420钢，钢筋包括 HPB235、HPB300、HRB335、HRB400、HRB500，抗拉强度范围在 370~680MPa 之间。本规程不适用于钢材表层与内部质量有明显差异或内部存在缺陷的建筑钢材的检测。

Technical specification for on-site testing of tensile strength of building steel by Leeb hardness method

JZ/T 1-2015 全屋定制家居产品　

本标准规定了全屋定制家居产品术语和定义、分类、材料、一般规定、技术要求、试验方法、检验规则、标志、包装、随行文件、运输和贮存、服务、现场验收。本标准适用于住宅内的定制家具及其配套的装修产品的生产和检验。

The all and the one custom-made housing products

DB43/T 1081-2015 建筑用保温免拆模板

Building insulation free formwork

EN 12390-11:2015 硬化混凝土试验.第11部分:混凝土的抗氯离子性的测定,单向扩散

This European Standard is a method for determining the unidirectional non-steady state chloride diffusion and surface concentration of conditioned specimens of hardened concrete. The test method enables the determination of the chloride penetration at a specified age, e. g. for ranking of concrete quality by comparative testing. Since resistance to chloride penetration depends on the ageing, including the effects of continual hydration, then the ranking may also change with age. The test procedure does not apply to concrete with surface treatments such as silanes and it may not apply to concrete containing fibres (see E.1).

Testing hardened concrete - Part 11: Determination of the chloride resistance of concrete, unidirectional diffusion

JC/T 2327-2015 水性聚氨酯地坪

本标准规定了水性聚氨酯地坪涂料和水性聚氨酯水泥复合砂浆的术语和定义、分类和标记、要求、试验方法、检验规则以及标志、包装、运输和贮存。本标准适用于建筑地面用水性聚氨酯地坪涂料和水性聚氨酯水泥复合砂浆类涂装材料。

Waterborne polyurethane screed material

EN 13381-9:2015 确定结构构件抗火性能的试验方法.第9部分:腹板开孔钢梁上的防火保护系统

This European Standard specifies a test and assessment method for determining the contribution made by fire protection systems to the fire resistance of structural steel beam I and H members in the horizontal plane containing openings in the web which may affect the structural performance of the beam. This European Standard applies to beams subject to 3 or 4 sided fire exposure. For any beam with a single web opening or where the web openings are considered to be of small diameter in relation to the web depth the applicability of this European Standard needs to be determined by a structural engineer. This European Standard applies to fire protection materials that have already been tested and assessed in accordance with EN 13381-4 or EN 13381-8. i.e. this European Standard cannot be used in isolation. Use of this European Standard requires the multi-temperature analysis (MTA) derived from EN 13381-4 or EN 13381-8 as the basis for determining thickness for beams with web openings. This MTA needs to be carried out on the web and bottom flange separately generating an elemental multi-temperature analysis (EMTA). The bottom flange EMTA may be used as the top flange EMTA when a beam is subject to 4 sided exposure. This European Standard contains the fire test methodology, which specifies the tests which need to be carried out to provide data on the thermal characteristics of the fire protection system, when exposed to the standard temperature/time curve specified in EN 1363-1. This European standard also contains the assessment, which prescribes how the analysis of the test data should be made and gives guidance on the procedures which should be undertaken. The assessment procedure is used to establish: a) on the basis of the temperature data derived from testing unloaded steel sections, the thermal response of the fire protection system on cellular beams (the thermal performance); b) the temperature ratio between the web post and the web reference temperature, which will vary depending on the web post width; c) the temperature ratio between points around the web openings and the web reference area; d) the elemental multi temperature analysis from either EN 13381-4 or EN 13381-8 needs to be reassessed and reported against elemental A/V for each fire resistance period; e) a structural model needs to be used to derive limiting temperatures for cellular beams using the data from b), c) and d) above.

Test methods for determining the contribution to the fire resistance of structural members - Part 9: Applied fire protection systems to steel beams with web openings

DB44/T 1602-2015 石材成分分析方法--X射线荧光光谱法

本标准规定了石材成分分析方法—波长色散型X射线荧光光谱法的原理、试剂和材料、仪器和装置、试验片的制备、分析步骤、结果的计算与表示、测定结果的重复性限与再现性限。 本标准适用于天然石材岩矿、天然石材荒料、各类天然石材板材及其制品的化学成分的测定。人造合成石材可参照该方法测定。

Analysis Method of Stone Composition--X-ray Fluorescence Spectrometry

DB37/T 5033-2015 彩色防滑涂层施工技术规程（丙烯酸类）

本规程适用于在水泥或沥青路面上，以丙烯酸类涂料为基料，并采用涂敷工艺施工的彩色防滑涂层工程。不适用于在透水路面上施工。

Technical specification for construction of colored anti-skid coating (acrylic)

DB37/T 5031-2015 SMC玻璃钢检查井应用技术规程

本规程主要适用于建筑小区、市政非机动车道和其他工业与民用建筑的排水工程中，管道外径不大于 1200mm、埋设深度不大于5ｍ、连续排入水温不大于 50℃ 的SMC玻璃钢检查井工程的设计、施工、验收。

SMC FRP Inspection Well Application Technical Regulations

EN 933-8:2012+A1:2015 集料几何特性试验.第8部分:细砂当量试验评估

This European Standard describes the reference method used for type testing and in case of dispute for the determination of the sand equivalent value of 0/2 mm fraction (for 0/4 mm) in fine aggregates or all-in aggregates. For other purposes, in particular factory production control, other methods may be used provided that an appropriate working relationship with the reference method has been established.

Tests for geometrical properties of aggregates - Part 8: Assessment of fines - Sand equivalent test

DB37/T 5030-2015 柔性石材墙体饰面工程应用技术规程

本规程适用于以柔性石材作为墙体饰面材料的新建、改 建、扩建工程的设计、施工及验收。

Technical specification for application of flexible stone wall facing engineering

DB37/T 132-2015 日用玻璃窑炉保温技术导则

Insulation Technical Guidelines for Glass Furnaces for Daily Use

JC/T 2295-2014 建筑材料及构件复合环境试验 人工光源辐照-冷冻循环试验方法

本标准规定了在人工光源辐照-冷冻循环试验方法的术语和定义、试验设备、试验方法、性能评价以及试验报告。本标准适用于评价在我国寒冷、寒温、干热地区使用的建筑材料与建筑构件在太阳辐照和冷冻交替的条件下的使用、贮存与运输过程中的性能变化。

Comprehensive environment test method for materials and elements of building construction.Artificial radiation-cold test

JC/T 2297-2014 建筑材料及构件复合环境试验 人工光源辐照-雨雪冰冻试验方法

本标准规定了在人工光源辐照下的雨雪冰冻试验方法的术语和定义、试验设备、试验方法以及试验报告。本标准适用于评价在我国冬季有冻雨地区使用的建筑材料与建筑构件,在太阳辐照并伴有降雨及冰冻条件下的使用、贮存与运输过程中的性能和变化。

Comprehensive environment test method for materials and elements of building construction.Artificial radiation-rain-freeze test

JC/T 2296-2014 建筑材料及构件复合环境试验 人工光源辐照-湿热试验方法

本标准规定了在人工光源辐照-湿热的复合试验方法的术语和定义、试验设备、试验方法、性能评价以及试验报告。本标准适用于评价在我国湿热、亚湿热地区使用的建筑材料与建筑构件在使用、贮存与运输过程中的性能变化。

Comprehensive environment test method for materials and elements of building construction.Artificial radiation-damp heat test

JC/T 2294-2014 二氧化硫凝露气氛下的腐蚀试验

本标准规定了建筑材料二氧化硫凝露气氛腐蚀试验方法的术语和定义、试验设备、试样、试验、清洗、性能评价以及试验报告。本标准适用于评价建筑材料在含二氧化硫凝露气氛条件下的性能和变化,建筑构件可参照本标准。

Testing in sulfur dioxide test with condensation of moisture

JC/T 2281-2014 道路用建筑垃圾再生骨料无机混合料

本标准规定了道路用建筑垃圾再生骨料无机混合料的术语和定义、分类、原材料、技术要求、配合比设计、制备、试验方法、检验规则以及订货和交货。本标准适用于城镇道路路面基层及底基层用建筑垃圾再生骨料无机混合料,公路各等级道路可参照本标准执行。

Construction waste recycle aggregate mixture for road

JIS A 1470-2 AMD 1:2014 建筑材料的水蒸气吸附和解吸性能的测定.第2部分:温度效应(修改件1)

Determination of water vapour adsorption/desorption properties for building materials -- Part 2: Response to temperature variation (Amendment 1)

JIS A 1470-1:2014 建筑材料的水蒸气吸附/解吸性能的测定.第1部分:湿度变化效应

Determination of water vapour adsorption/desorption properties for building materials -- Part 1: Response to humidity variation