Q10 建材产品综合 标准查询与下载
共找到 505 条与 建材产品综合 相关的标准，共 34 页
本规程适用于建筑地下防水工程、 建筑屋面防水工程、建筑外墙防水工程及建筑室内防水工程的防水设防。
Polymer cement waterproof material engineering application technical specification
- ICS
- 91.120.30
- CCS
- Q10
- 发布
- 2014-12-15
- 实施
- 2015-01-01
This European Standard specifies a method for determining the wear resistance of moulded specimens made from cementitious screed material, primarily for hard aggregate wearing screed materials or optionally for other screed materials. The method is also suitable for specimens cut from floor screed. This method is unsuitable for synthetic resin screed materials.
Methods of test for screed materials - Part 3: Determination of wear resistance - B?hme
- ICS
- 91.100.10
- CCS
- Q10
- 发布
- 2014-12
- 实施
本标准规定了采用热湿气候风洞法测量建筑材料和构件动态热湿传递性质的试验方法。 本标准适用于块状、颗粒状、植被类建筑材料和构件动态热湿传递性质的测定。
Test methods for dynamic heat and moisture transfer properties of building materials and components - Wind tunnel method for hot and humid climates
- ICS
- 91.100.01
- CCS
- Q10
- 发布
- 2014-11-10
- 实施
- 2015-02-10
本标准规定了外墙外保温系统用水泥基界面剂和填缝剂的术语和定义、分类和标记、一般要求、技术要求、试验方法、检验规则以及标志、包装、运输、贮存和产品随行文件。本标准适用于建筑外墙外保温系统用水泥基界面剂和填缝剂。
Cement interface treating agent & tile grout for external thermal insulation composite systems
- ICS
- 91.100.40
- CCS
- Q10
- 发布
- 2014-10-14
- 实施
- 2015-04-01
本标准规定了建筑无机仿砖涂料的术语和定义,分类、代号和标记,要求,试验方法,检验规则,标志、包装、运输和贮存。本标准适用于建筑外墙用无机仿砖涂料。
Architectural inorganic brick imitating coatings
- ICS
- 91.100.99
- CCS
- Q10
- 发布
- 2014-09-11
- 实施
- 2015-02-01
This European Standard specifies requirements for slate and carbonate slate for discontinuous roofing and external cladding, as defined in 3.1, and 3.2, used for assembly into discontinuous roofing and external cladding. For the purposes of this European Standard, slates and carbonate slates have been classified. This European Standard does not apply to products for roofing or external cladding made from the following: a) stone other than those defined in 3.1 and 3.2; b) concrete; c) polymeric materials; d) fibre reinforced cement; e) metal; f) clay. This European Standard is not applicable to roofing and cladding slates used internally. This European Standard is not applicable to bonded cladding (cladding fixed with adhesives) and cladding fixed with dowels and cramps. NOTE 1 Requirements for internal wall lining slate are specified in EN 1469. This document does not include requirements for appearance. NOTE 2 Some general guidance for appearance is given in Annex A. This European Standard does not include installation rules for slates. NOTE 3 References to national recommendations on methods of construction for slate roofs are given in Annex C. NOTE 4 Where the term "slate" is used in this document it means slate and carbonate slate unless otherwise indicated.
Slate and stone for discontinuous roofing and external cladding - Part 1: Specifications for slate and carbonate slate
- ICS
- 91.100.15
- CCS
- Q10
- 发布
- 2014-08
- 实施
Flexible cellular polymeric materials. Determination of fatigue by constant-load pounding
- ICS
- 83.100
- CCS
- Q10
- 发布
- 2014-07-31
- 实施
- 2014-07-31
本标准规定了无机干粉建筑涂料的术语和定义、分类、代号和标记、要求、试验方法、检验规则、标志、包装、运输和贮存。本标准适用于建筑内外墙用无机干粉建筑涂料。
Architectural inorganic powder coatings
- ICS
- 91.100.99
- CCS
- Q10
- 发布
- 2014-07-14
- 实施
- 2014-12-01
This European Standard specifies the characteristics of semi-rigid multilayer modular floor covering with a wear-resistant and decorative surface layer supplied in panels (either tile or plank form). The floor panels are considered suitable for domestic and commercial levels of use and designed for floating installation. This European Standard does not apply to resilient floor panels for loose-laying according to EN 14085, to multilayer wood floorings according to EN 13489, nor to products specified in EN ISO 10581, EN ISO 10582, EN ISO 24011, EN 12104 and ISO 14486. This European Standard applies to areas which are subject to frequent wetting, e. g. bathrooms, laundry rooms or saunas, only if recommended by the producer. This European Standard also includes requirements for marking and packaging.
Loose-laid panels - Semi-rigid multilayer modular floor covering (MMF) panels with wear resistant top layer
- ICS
- 97.150
- CCS
- Q10
- 发布
- 2014-05
- 实施
Technical specification for domestic garbage geotechnical test
- ICS
- CCS
- Q10
- 发布
- 2014-03-01
- 实施
- 2014-03-01
This Technical Specification gives guidance in case of complaints when a colour deviation is observed after installation of a textile floor covering by the installer and/or end user. The colour deviation can be observed within different parts of the installation or between the installed textile floor covering and the initially presented sample on which the choice for ordering was made.
Textile floor coverings - Guidelines for acceptable colour deviations
- ICS
- 59.080.60
- CCS
- Q10
- 发布
- 2014-03
- 实施
Fire resistance tests. Elements of building construction. Specific requirements to determine the contribution of applied fire protection materials to structural steel elements
- ICS
- 13.220.50
- CCS
- Q10
- 发布
- 2014-02-28
- 实施
- 2014-02-28
이 표준은 대형 챔버를 이용하여 건축 자재의 세균 저감 성능을 평가하는 시험방법으로 건축용 보드류, 벽지, 도료 및 기타 정형화되어 있지 않은 건축 자재 등에 적용한다.
Test method for bacterial reduction rate of building material ― Large chamber method
- ICS
- 13.040;13.040.20
- CCS
- Q10
- 发布
- 2013-12-30
- 实施
- 2013/12/30
本标准规定了无机类建材产品中固体废物掺量验证试验方法的术语和定义、试验仪器和试验方法。 本标准适用于水泥、预拌混凝土干混合料、砂浆、陶粒、墙体材料（砖、砌块、板材）、保温材料等无机类建材产品中固体废物掺量的验证试验。
Validation test methods for content of solid waste in inorganic building materials
- ICS
- 91.100.01
- CCS
- Q10
- 发布
- 2013-11-25
- 实施
- 2014-03-01
Hygrothermal performance of building materials and products. Determination of hygroscopic sorption properties
- ICS
- 91.100.01
- CCS
- Q10
- 发布
- 2013-08-31
- 实施
- 2013-08-31
This International Standard specifies two alternative methods for determining hygroscopic sorption properties of porous building materials and products: a) using desiccators and weighing cups (desiccator method); b) using a climatic chamber (climatic chamber method). The desiccator method is the reference method. This International Standard does not specify the method for sampling. The methods specified in this International Standard can be used to determine the moisture content of a sample in equilibrium with air at a specific temperature and humidity.
Hygrothermal performance of building materials and products.Determination of hygroscopic sorption properties
- ICS
- 91.100.01
- CCS
- Q10
- 发布
- 2013-08
- 实施
Clay roofing tiles and fittings. Product definitions and specifications
- ICS
- 01.040.91;91.100.25
- CCS
- Q10
- 发布
- 2013-06-30
- 实施
- 2013-06-30
Hygrothermal performance of building materials and products - Determination of moisture content by drying at elevated temperature; Amendment 1
- ICS
- 91.100.01
- CCS
- Q10
- 发布
- 2013-06-01
- 实施
Method of abrasion test for building materials and part of building construction (Method of abrasion test for flooring materials method with rotating disk fitted friction and impact) (Amendment 2)
- ICS
- 91.100.01
- CCS
- Q10
- 发布
- 2013-05-25
- 实施
本标准规定了硅藻泥装饰壁材的术语和定义、要求、试验方法、检验规则以及标志、包装、运输和贮存等。本标准适用于含有硅藻材料的干粉状内墙装饰涂覆材料。
Diatomaceous decorative interior wall materials
- ICS
- 91.100
- CCS
- Q10
- 发布
- 2013-04-25
- 实施
- 2013-09-01
