S30 机车车辆通用标准综合 标准查询与下载

JJG(铁道) 194-2007 铁道车辆轴承游隙测量仪检定规程

本规程适用于分辨力为0.001mm的铁道车辆轴承游隙测量仪的首次检定、后续检定和使用中检验。

Ball Bearing Clearance Checker for Railway Vehciles

JJG(铁道) 193-2007 机车车辆专用压力表检定规程

本规程适用于测量范围为（0～1600）kPa系列的铁路机车车辆专用压力表（以下简称压力表）的首次检定、后续检定、使用中检验、产品监督抽查和样机试验。

Bourdon Pressure Gauge for Railway Locomotives and Vehicles

BS EN 61287-1:2006 轨道交通.安装在铁路机车上的功率变换器.第1部分:特征和试验方法

This International Standard is applicable to power electronic convertors mounted on board railway rolling-stock and intended for supplying – traction circuits; – auxiliary circuits of power vehicles, coaches and trailers. The application of this standard extends as far as possible to all other traction vehicles, including trolley-buses, for example. This standard covers the complete convertor assembly together with its mounting arrangements containing – semiconductor device assemblies; – integrated cooling systems; – components of the intermediate d.c. link, including any necessary filters associated with the d.c. link; – semiconductor drive units (SDU) and related sensors; – incorporated protection circuits. The following types of power sources are taken into consideration: – a.c. contact lines, – d.c. contact lines, – on-board supplies such as generators, batteries and other electric power sources. This standard excludes convertors which provide the electronic control supply for SDU and other supplies relevant to the convertor operation such as sensors. NOTE Electronic control equipment of convertors and those sensors not related to semiconductor drive units and the printed circuit board assemblies of drive units for power semiconductors (SDU) are covered by IEC 60571. This standard defines terminology, service conditions, general characteristics and test methods of electronic power convertors onboard of rolling stock.

Railway applications - Power convertors installed on board rolling stock - Part 1: Characteristics and test methods

DIN 27201-9:2006 铁路车辆状况.基本原理和生产技术.第9部分:测量

This document applies to measuring of components in railway vehicles.

State of railway vehicles - Basic principles and production technology - Part 9: Measuring

DIN 27202-10:2006 铁路车辆状态.车辆的上层结构和专用设备.第10部分:上层结构测量

This document contains general regulations for the measurement of super structures.

State of railway vehicles - Superstructure and special equipment of vehicles - Part 10: Measurement of superstructures

BS EN 15380-1:2006 轨道交通.铁路车辆用命名系统.一般原则

As a railway-specific technical standard, this European Standard specifies the designation system for technical products and technical project documentation. It takes into account the general rules for structuring principles according to EN 61346-1 and designations according to EN 61355. The European Standard specifies the structure and content of the designation sets required in the technical project documentation. The designation depends on the aspect used, see Annex C, individually or in designation set combinations, i.e.: product groups according to EN 15380-2; installation site/location according to EN 15380-3; function structure according to DIN 25002-5.

Railway applications - Designation system for railway vehicles - Part 1: General principles

BS EN 14813-1:2006 轨道交通.机车驾驶室用空调.舒适参数

This European Standard is applicable to railway vehicle driving cabs which are air-conditioned or heated/ventilated. These include:  locomotives;  mainline, suburban and regional vehicles;  urban vehicles such as metros and trams. This European Standard does not consider the special operational requirements of shunt locomotives. This European Standard specifies the comfort parameters for the driving cab to ensure driver comfort which helps safe operation. The conditions under which the physical parameters mentioned in this European Standard shall be measured are defined in EN 14813-2.

Railway applications - Air conditioning for driving cabs - Comfort parameters

BS EN 14067-5:2006+A1:2010 轨道交通.空气动力学.隧道中空气动力学的试验规程和要求

Railway applications. Aerodynamics. Requirements and test procedures for aerodynamics in tunnels

BS EN 14067-5:2006 轨道交通.空气动力学.隧道中空气动力学的要求和试验程序

This European Standard applies to the aerodynamic loading caused by trains running in a tunnel.

Railway applications - Aerodynamics - Requirements and test procedures for aerodynamics in tunnels

BS EN 14813-2:2006 轨道交通.机车驾驶室用空调.类型试验

This European Standard is applicable to railway vehicle driving cabs which are air-conditioned or heated/ventilated. These include:  locomotives;  mainline, suburban or regional vehicles;  urban vehicles such as metros and trams. This European Standard does not consider the special operational requirements of shunt locomotives. This European Standard specifies the comfort parameter measurement methods for driving cabs. The comfort parameters and their tolerances cited in this European Standard are defined in EN 14813-1.

Railway applications - Air conditioning for driving cabs - Type tests

JJF(铁道) 601.11-2006 标准轨距铁路机车车辆限界规检定系统

Verification Scheme of Rolling Stock Gauge for Standard Gauge Railway

JJF(铁道) 601.9-2006 铁路专用轻便型红外测温仪检定系统

Verification Scheme of Portable Infrared Ray Temperature Measurement Tool of Railway

JJF(铁道) 601.13-2006 铁路轨道检查仪检定系统

Verification Scheme of Inspecting Instrument for Static Geometry Parameter of Track

JJF(铁道) 601.12-2006 列车尾部安全防护装置检定系统

Verification Scheme of the Train Tail Safety Protection Device

JJF(铁道) 601.10-2006 铁道车辆轮重测定仪检定系统

Verification Scheme of Measurement Machines for Wheel-Height of Railway Vehicles

NF F11-535-1:2006 轨道交通.铁路车辆的制动盘.第1部分:加压或热套到轴或驱动轴的制动盘的尺寸和质量要求

Railway applications - Brake discs for railway rolling stock - Part 1 : brake discs pressed or shrunk onto the axle or drive shaft, dimensions and quality requirements.

DIN EN 14750-1:2006 轨道交通.城市和郊区铁路车辆用空调.第1部分:舒适度参数

Railway applications - Air conditioning for urban and suburban rolling stock - Part 1: Comfort parameters English version of DIN EN 14750-1:2006-08

BS EN 15380-3:2006 轨道交通.铁路车辆用标记系统.安装位置和定位的标记

As a railway-specific technical standard, this document gives rules for the designation of installation sites and locations in railway vehicles.

Railway applications - Designation system for railway vehicles - Designation of installation sites and locations

DIN 25002-5:2006 轨道交通.铁路车辆命名制度.第5部分:功能组件

Railway applications - Designation systematic for railway vehicles - Part 5: Functional assemblies

BS EN 14750-1:2006 轨道交通.城市和郊区全部车辆的空气调节装置.舒适参数

This European Standard is applicable to suburban and/or regional vehicles and also metro and tramway vehicles equipped with cooling and/or heating/ventilation systems. This European Standard excludes main line vehicles and driving cabs which are considered in separate European Standards. This European Standard specifies comfort parameters for compartment or saloon (single level or doubledecker). These comfort parameters apply in a similar way to the areas reserved for train staff, with the exception of the catering service areas. The conditions under which the physical parameters mentioned in this European Standard shall be measured are defined in EN 14750-2.

Railway applications - Air conditioning for urban and suburban rolling stock - Comfort parameters